Download  Print this page

Automatic Screen Layouts; Settings - Philips FM20 Instructions For Use Manual

Avalon fetal monitor.
Hide thumbs

Advertisement

Mode
Configuration Mode
Service Mode
A field displayed at the fetal monitor screen indicates if the monitor is in Demonstration Mode,
Configuration Mode, or Service Mode. To change to a different mode, select this field.

Automatic Screen Layouts

Your monitor's preconfigured screen layouts define how measurement information is arranged on the
screen. The monitor automatically applies the correct screen layout for the measurements you are
monitoring. No user action is required.
Connecting or disconnecting transducers, or activating or deactivating a cableless measurement, results
in an automatic adjustment of the screen layout. When a measurement is off, its numerics are removed
from the monitor's screen. The monitor stops acquiring data and generating alarms for this
measurement. If you disconnect a transducer while it is performing a measurement, the monitor issues
a disconnect INOP (and in the case of SpO
mark).

Settings

This section describes the various settings available on the monitor.
Active Settings
What the monitor displays, and the way it operates, is controlled by its settings. They determine sound
volume settings, recorder settings, high and low alarm limits and so forth.
The "active settings" are the current settings the monitor uses, including any adjustments made by the
last user. Active settings are not permanent, but are retained after a loss of mains power.
There are also two preconfigured default settings:
User Default
Factory Default
Description
The Configuration Mode is for personnel trained in
configuration tasks. You can change and store the default
values and patient profiles permanently in the
Configuration Mode. These tasks are described in the
Configuration Guide. During installation, the fetal
monitor is configured for use in your environment. This
configuration defines the default settings you work with
when you switch on the fetal monitor.
The Service Mode is for trained and authorized service
personnel only.
, replaces the measurement numeric with a question
2
3 Basic Operation
Password
Protected
yes
yes
45

Advertisement

Table of Contents

   Also See for Philips FM20

   Related Manuals for Philips FM20

This manual is also suitable for:

Fm30Avalon clFm40Fm 50

Comments to this Manuals

Symbols: 0
Latest comments: