Eu-Declaration Of Conformity; Fcc Statement - Oregon Scientific ECLIPSE User Manual

Oregon Scientific Global Distribution Limited reserves
the right to interpret and construe any contents, terms
and provisions in this user manual and to amend it, at
its sole discretion, at any time without prior notice. To
the extent that there is any inconsistency between the
English version and any other language versions, the
English version shall prevail.

EU-DECLARATION OF CONFORMITY

Hereby the manufacturer, Oregon Scientific Global Distribution
Limited, declares that the radio equipment type Advanced
Wireless Weather Station (Model: ECLIPSE) is in
compliance with 2014/53/EU Directive. The full text of the
EU Declaration of Conformity is available at the following
internet address:
http://global.oregonscientific.com/customerSupport.php.
COUNTRIES RED APPROVED COMPLIED
All EU countries, Switzerland

FCC STATEMENT

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
WARNING:
expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and
•
receiver.
Connect the equipment into an outlet on a circuit
•
CH
different from that to which the receiver is connected.
and Norway
N
Consult the dealer or an experienced radio / TV
•
technician for help.
9
Changes or modifications to this unit not