Input Programming - Aiphone RY-IP44 User Programming Manual

When the relay action is set for the "Door Release" options, the relay will trigger when the associated door station is in
communication, and a master station within the configuration list requests door release.
When the relay action is set for any of the "Active While" options, the relay will trigger when the associated door station
calls or communicates at any priority level.
After the Door TermID and Relay Action has been set, click Apply Settings at the bottom of the screen to save the
settings to memory. Return to the Application Screen or reboot adaptor by clicking on the Reboot button.
To program a master station to control door release, click on the Configure button. A new window will open and the
table shown below will be populated based on the entries made in the Linked Stations Table (see page 8).
Check the Flag box beside each master station that will be "allowed" to trigger this relay for door release. Once all
master stations have been checked, click Apply Settings at the bottom of this window to save the settings to memory.
Reboot to update adaptor settings.
Note: The IS-SOFT software master stations can NOT be enabled for door release using the RY-IP44.
IX Series
IS-IP Series:

Input Programming

The RY-IP44 adaptor has 4 inputs that can be programmed to trigger a call-in from a specific door station to a specific
master station or group of master stations (max. 20). The RY-IP44 inputs can have different calling rules than the default
calling rule set under Advanced Station Settings in the IS Host Programming.
Choose the Call-In priority level for each input using the Priority drop down menu. Enter the target IP address of the
door station for remote call-in.
Click Apply Settings to save the changes. Do not reboot the adaptor at this time.
Click APPLICATION SETUP to return to the Application Configuration screen.
IS-IP Series
Station Placing Call
RY-IP44
9