Honeywell F50F Manual page 9
Duct mounted electronic air cleaner
Hide thumbs
Also See for F50F:
- Owner's manual (58 pages) ,
- Installation instructions manual (25 pages) ,
- Product data (24 pages)
Table of Contents
Advertisement
Available languages
Available languages
Remove the W8600E base and drill the holes. Install the
anchors and screws so the base is mounted firmly on the
wall at the correct distance from the T8600.
Fig. 9—Mounting W8600E indicator next to
T8600 Thermostat, dimensions in in. [mm].
W8600E
BASE
MOUNTING
TEMPLATE
T8600 THERMOSTAT
ENRG. SAV. SYSTEM
AM
MON
HEAT ON
WAKE
11
3
16
[94]
5
[42]
1
8
MOUNTING HOLES
WIRING HOLE
M6167
Wiring W8600E
IMPORTANT: Run wires separately from any other cur-
rent-carrying wires.
All wiring must comply with local codes and ordinances.
Run 4-wire thermostat cable (up to 18 gauge), indepen-
dently of any other current-carrying wires, from the W8600E
base to the terminal strip on the power box of the elec-
tronic air cleaner.
Strip 1/4 in. of insulation from the ends of the wires and
connect them (1 to 1, 2 to 2, 3 to 3, 4 to 4) as shown in Fig. 8.
Install the W8600E cover and visually check the instal-
lation as shown in Fig. 10.
Fig. 10—Completed installation of T8600 with
W8600E.
ON.
WASH
CHECK
ENRG. SAV. SYSTEM
AM
MON
HEAT ON
WAKE
M6166
F50F
INSTALLATION
SEAL JOINTS
Seal all joints in the return air system between the air
cleaner and the furnace to prevent dust from entering the
clean airstream.
DISABLE UNUSED PREFILTER GUIDE
Crimp the end of the downstream (closest to the furnace)
prefilter guide to prevent incorrect prefilter installation
following cleaning. See Fig. 11.
Fig. 11—Crimping prefilter guide.
M5640
POSITION CELL KEY
The electronic cell must always be installed so the
ionizer section is on the upstream side. A factory-installed
cell key on the bottom of the cabinet allows the cell to be
inserted in only one direction. As long as the arrow molded
into the plastic key points in the same direction as the
airflow, the ionizer will always be on the upstream side.
If the position of the key must be reversed, proceed as
follows:
1. Remove the electronic cell.
2. Remove the screw holding the cell key in place. See
Fig. 12.
Fig. 12—Position of cell key determines orienta-
tion of cell (arrow on key must point down-
stream).
DOWNSTREAM
AIRFLOW
CELL KEY
CELL
SCREW
KEY
CELL KEY
PREFILTER GUIDES
ALTERNATE
HOLES FOR
KEY
M5639
Page 9
Hide quick links:
Advertisement
Table of Contents
