INSTALLATION
INSTRUCTIONS
Put this information in the glove box with the vehicle owner's manual.
PARTS LIST
Bike attachments
2 Wheels Straps
2 End Caps
2 Keys
TOOLS REQUIRED
Flat-tip screwdriver
Shop towel
Utility Knife
INSTALLATION
NOTE:
•
Be careful not to damage the painted surfaces of
the vehicle when installing the bike attachment.
•
If you are installing more than one bike attachment,
you may need to alternate the mounting positions
(front to rear) to allow for handle bar clearance.
•
Make sure the security retainer and the locking
clamp lever are installed on the outboard side. See
the instruction sheet for details
© 2009 American Honda Motor Co., Inc. - All Rights Reserved.
Accessory
BIKE ATTACHMENT
P/N 08L07-TA1-102
Preparing the Bike Attachment
1.
2.
AII 42593 (0909)
Application
2010 CR-V
Slide the wheel strap onto one end of the bike
attachment channel. Repeat on the other end.
Make sure both wheel strap buckles are on the
same side.
WHEEL
STRAP
BIKE ATTACHMENT
Install an end cap on the bike attachment channel
by aligning the locktabs on the end cap, with the
holes in the channel. Push down on the endcap
until the lock tabs "click" into place. Repeat on
the other end.
END CAP
Publications No.
AII 42593
Issue Date
SEPT 2009
BIKE ATTACHMENT
1 of 3
08L03-TA1-2000-91