Controlling Combo Devices - Philips SRP9232D/27 User Manual

Programming Your Remote
7.
8. Repeat this process for each

Controlling Combo Devices

Some combo devices (e.g. TV/VCR, TV/DVD,
DVD/VCR, etc.) will require you to set up
two different device buttons to control both
parts of the combo device. For example, if
you have a TV/DVD combo, you may need
to set up one code under the TV button to
control the TV and a separate code under
the DVD button to control the DVD.
store the code in the remote.
Go to Step 7.
• If NO, continue to press and
release the VOL
until the device turns off
to test the other 9 codes
from Step 4. Be sure to wait
approximately 3 seconds after
each VOL
to allow the device time to
respond to the code. When
the device turns off, you have
found a code for your device.
Press and release the same
device button pressed in Step
3. This will store the code in
the remote. Go to Step 7.
NOTE:
VOL
• The
to go backwards through each
batch of 10 codes.
• The red indicator light will flash
2 times after testing the first or
last code in each batch of 10.
Use the remote to turn the
device back on. Test the buttons
on the remote to see if the
device responds as you would
expect. If the buttons do not
operate the device, return to
Step 2 and repeat this process
to search for a better code to
operate the device.
device you wish to control.
button press
button can be used
9
button