Honeywell SmartDrive Compact User Manual page 32

Honeywell
Monitoring values mean actual values of measured signals as well as statuses of
some control settings. They are visible in display, but they cannot be edited. The
monitoring values are listed in Table 7.1.
Pushing the navigation wheel once in this menu takes the user to the next level,
where the monitoring value, e.g. M1.11 and value are visible (see Figure 7.2). The
monitoring values can be browsed by rolling the navigation wheel clockwise, as
shown in Figure 7.4.
Code Monitoring signal
M1.1 Output frequency
M1.2 Frequency reference
M1.3 Motor shaft speed
M1.4 Motor current
M1.5 Motor torque
M1.6 Motor power
M1.7 Motor voltage
M1.8 DC-link voltage
M1.9 Unit temperature
M1.10 Motor temperature
M1.11 Analogue input 1
M1.12 Analogue input 2
M1.13 Analogue output
M1.14 DI1, DI2, DI3
M1.15 DI4, DI5, DI6
M1.16 RO1, RO2, DO
M1.17 PI setpoint
M1.18 PI feedback
M1.19 PI error value
M1.20 PI Output
Table 7.1 : SmartDrive Compact monitoring signals
Control Panel
Unit ID
Hz 1 Frequency to the motor
Hz 25
rpm 2 Calculated motor speed
A 3 Measured motor current
Calculated actual/nominal torque of
% 4
the motor
Calculated actual/nominal power of
% 5
the motor
V 6 Motor voltage
V 7 Measured DC-link voltage

8 Heat sink temperature
C

Calculated motor temperature
C
% 13 AI1 value
% 14 AI2 value
% 26 AO1
15 The status of digital inputs
16 The status of digital inputs
The statuse of Relays and digital
17
output
In percent of the maximum process
% 20
reference
In percent of the maximum actual
% 21
value
In percent of the maximum error
% 22
value
In percent of the maximum output
% 23
value
31
Description
7