Chapter 5 Safety Application Configuration Examples; System Configured By A Safety Cpu; System Configuration - Mitsubishi Electric MELSEC iQ-R Series Safety Manual

5
SAFETY APPLICATION CONFIGURATION
EXAMPLES
This chapter describes a configuration example of a safety application using safety programmable controller.
5.1

System Configured by a Safety CPU

System configuration

This section describes a safety application using the following system configuration samples.
GX Works3* 1
CCIEF master (1)
Network No.1
Station No.0
*1 This sets parameters and programs.
*2 They are safety input device such as emergency stop switch, safety switch, light curtain, laser scanner, and mat switch.
*3 They are safety output device such as safety relay and MC.
*4 They are general input device such as reset switch, start switch, and stop switch.
The following table shows definitions of the symbols used in this chapter.
Symbol
CCIEF master (1)
CCIEF remote (1)
CCIEF remote (2)
CCIEF remote (1): SR_IO1
Network No.1
Station No.1
2
Safety input* Safety output*
Definition
MELSEC iQ-R series CC-Link IE Field Network master/local module (Master station number 0)
Safety remote I/O module (station number 1)
Standard remote I/O module (station number 2)
CCIEF remote (2): R_IO2
Network No.1
Station No.2
3
Standard input*
5 SAFETY APPLICATION CONFIGURATION EXAMPLES
5.1 System Configured by a Safety CPU
4
51
5