Samsung VP-DC161(I) Owner's Instruction Book page 119

Samsung dvd camcorder user manual
Hide thumbs Also See for VP-DC161(I):
Table of Contents

Advertisement

ENGLISH
Troubleshooting
 If these instructions do not solve your problem, contact your
nearest Samsung authorized service certre.
Symptom
Explanation/Solution
You cannot switch the
Check the Battery Pack or the AC Power
DVD Camcorder on.
adapter.
You have left the DVD Camcorder set to
STBY for more than 5 minutes without
The DVD Camcorder
using it. To turn on the DVD Camcorder,
shuts off automatically.
press the [Start/Stop] button.
The Battery Pack is fully exhausted.
Replace it with a fully charged battery pack.
The atmospheric temperature is too low.
The Battery Pack has not been charged fully.
Charge runs out
The Battery Pack is completely dead, and
quickly.
cannot be recharged, use another Battery
Pack.
The contrast between the subject and
A vertical strip appears
the background is too great for the DVD
on the screen when
Camcorder to operate normally. Make the
recording a dark
background bright to reduce the contrast
background.
or use the BLC function while you are
recording in bright Surroundings.
The Viewfinder lens has not been
adjusted.
The image in the
Adjust the Viewfinder control lever until
Viewfinder is blurred.
the indicators displayed on the Viewfinder
come into sharp focus.
Check the Manual Focus menu.
Auto focus does not
Auto focus does not work in the Manual
work.
Focus mode.
When the power is
If the DC Adapter is connected, remove
turned off and then
the cord, turn on the Power switch, and
turned on, a blue
then connect it again. If the battery is
screen appears instead
connected, disconnect it, turn the Power
of the normal screen.
switch to on, and then connect it again.
Fehlerbehebung
 Wenden Sie sich an den zuständigen Samsung-Kundendienst, wenn Sie das
Problem mit den hier geschilderten Maßnahmen nicht beheben können.
Symptom
Erklärung/Abhilfe
Der DVD-Camcorder lässt
Überprüfen Sie den Akku bzw. das Netzteil.
sich nicht einschalten.
Der DVD-Camcorder war über fünf Minuten im
Standby-Modus und wurde während dieser Zeit
Der DVD-Camcorder
nicht benutzt. Schalten Sie den DVD-Camcorder
schaltet sich automatisch
ein, drücken Sie die [Start/Stop]-Taste.
aus.
Der Akku ist leer. Ersetzen Sie den leeren Akku
durch einen vollständig aufgeladenen Akku.
Die Umgebungstemperatur ist zu niedrig.
Der Akku war nicht vollständig aufgeladen.
Der Akku entlädt sich sehr
Der Akku ist defekt oder zu alt und kann nicht
schnell.
mehr aufgeladen werden. Verwenden Sie
einen anderen Akku.
Der Kontrast zwischen Motiv und Hintergrund
Bei Aufnahmen vor einem
ist zu stark. Ein normaler Betrieb des DVD-
dunklen Hintergrund wird
Camcorders ist nicht möglich. Vermindern
ein vertikaler Streifen
Sie den Kontrast, indem Sie den Hintergrund
angezeigt.
aufhellen (Beleuchtung), oder schalten Sie den
Gegenlichtausgleich (BLC) ein.
Der Sucher ist falsch eingestellt.
Das Bild im Sucher ist
Verschieben Sie den Fokusregler am Sucher, bis
unscharf.
die Anzeige im Sucher scharf ist.
Überprüfen Sie, ob die manuelle
Der Autofokus funktioniert
Fokuseinstellung aktiviert ist.
nicht.
Der Autofokus funktioniert nicht, wenn der
manuelle Fokus eingestellt ist.
Bei Aus- und
Wenn der Netzadapter angeschlossen ist,
anschließendem
entfernen Sie das Kabel, schalten Sie das
Einschalten des Geräts
Gerät ein und schließen Sie das Kabel
wird anstatt des normalen
wieder an. Wenn der Akku angeschlossen ist,
Bildschirms ein blauer
entfernen Sie ihn, schalten Sie das Gerät ein
Bildschirm angezeigt.
und schließen Sie den Akku dann wieder an.
DEUTSCH
119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents