Download  Print this page

Cleaning & Maintenance - Kenwood CK 600 Instructions For Use - Installation Advice

Hide thumbs

Advertisement

6 - CLEANING AND MAINTENANCE
Important:
Before cleaning or carrying out
any maintenance disconnect the
appliance from the electrical sup-
ply and wait for it to cool down.
Attention
The appliance gets very hot,
mainly around the cooking areas.
It is very important that children
are not left alone in the kitchen
when you are cooking.
Do not use a steam cleaner
because the moisture can get
into the appliance thus make it
unsafe.
GENERAL ADVICE
– When the appliance is not being
used, it is advisable to keep the gas
tap closed.
– Every now and then check to make
sure that the flexible tube that
connects the gas line or the gas
cylinder to the appliance is in perfect
condition and replace it if is shows any
signs of wearing or damage.
– The periodical lubrication of the gas
taps must be done only by specialised
personnel.
– If a tap becomes stiff, do not force;
contact your local Service Centre.
18
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a soft cloth.
Acidic substances like lemon juice,
tomato sauce, vinegar etc. can damage
the enamel if left in contact for too long.
STAINLESS STEEL SURFACES
The stainless steel front panels on this
cooker (facia, oven door, storage com-
partment) are protected by a finger-print
proof lacquer.
To avoid damaging this lacquer, do not
clean the stainless steel with abrasive
cleaners or abrasive cloths or scouring
pads.
ONLY SOAPY/WARM WATER MUST
BE USED TO CLEAN THE STAINLESS
STEEL SURFACES.
WARNING
When correctly installed, your product
meets all safety requirements laid down
for this type of product category.
However special care should be taken
around the rear or the underneath of
the appliance as these areas are not
designed or intended to be touched and
may contain sharp or rough edges, that
may cause injury.
REPLACING THE OVEN LIGHT BULB
Switch the cooker off at the mains.
When the oven is cool, unscrew and
replace the bulb with another one
resistant to high temperatures (300°C),
voltage 230 V (50 Hz), 15 W, E14.
Note: Oven bulb replacement is not
covered by your guarantee.

Advertisement

Table of Contents
loading

  Related Manuals for Kenwood CK 600