Mks-8010A Rear Panel - Sony MKS-8010A Operation Manual

MKS-8010A Rear Panel

qgMENU PANEL connector
MENU PANEL
EXT DISPLAY
DATA
qaDATA connector
qfEXT DISPLAY connector
a REMOTE connector (BNC type)
Connect this connector with a BNC cable to an S-BUS data
link via a T bridge.
An S-BUS data link is a single signaling circuit (S-BUS)
to which multiple devices can be connected to exchange
data.
Connecting devices such as HDS-X3000 series routing
switchers and remote panels to an S-BUS data link enables
the following kinds of control.
• Returning to the S-BUS, tally data created by this unit on
the basis of data received from other devices
• Switching the cross-points of a routing switcher from the
center control panel
• Switching the cross-points of a switcher from the remote
panel
• Displaying on the center control panel source names set
on a routing switcher
b REF IN (reference signal input) connectors
(BNC type)
If you wish to synchronize this unit to an external reference
signal, input the reference signal. For an HDTV system,
input an HD tri-level sync signal, black burst signal, or
analog sync signal. For an SDTV system, input a black
burst signal or analog sync signal.
The two connectors have a loop-through configuration.
Signal input to one connector can be output from the other
connector. If you will not be using the loop-through
3EXT PANEL 1 to 3 connectors
EXT PANEL1 EXT PANEL2
DEVICE EDITOR PANEL REF IN REMOTE CTRL
1REMOTE connector
2REF IN connectors
8EDITOR PANEL connector
q;DEVICE connector
qsMAIN PANEL connector
EXT PANEL3 MAIN PANEL
PERIPH LTC IN GPI
4GPI connector
5LTC IN connector
9PERIPH connector
qdCTRL connector
output, be sure to terminate the unused connector with the
supplied 75Ω terminator.
c EXT (extension) PANEL 1 to 3 connectors
(D-sub 50-pin, special interface)
Connect to the MKS-8075A Extension Adaptors and AUX
panels to install operation modules apart from the center
control panel.
d GPI (General Purpose Interface) connector
(D-sub 25-pin)
Connect to external devices for input and output of trigger
signals. Up to eight inputs and eight outputs are possible,
with input and output conditions set on the center control
panel.
e LTC IN (longitudinal timecode input) connector
(BNC type)
Connect to a timecode generator.
f - AC IN (AC power input) A and B connectors
(3-pin)
Connect to 100 to 240 V AC power supply with the
optional AC power cords.
Depending on the configuration of your unit, the Backup
Power Supply Unit may not be installed. In that case, the
AC IN B connector is not used.
6-AC IN A and B connectors
-
AC IN
B A
U
7U terminal
Location and Function of Parts
11