Mounting - Honeywell Galaxy TouchCenter Plus Installer Manual

Mounting

This keypad is for indoor use within the protected area only and should be mounted at a comfortable viewing level.
Avoid mounting in areas of high condensation such as bathrooms or in locations where bright light or sunlight shines
directly on the screen.
To mount the keypad:
1. Unclip the facia from the keypad to reveal four mounting screw holes.
2. If the customer has supplied an SD/SDHC media card containing videos and/or photos, fit the card in the slot in the
rear of the keypad as shown below.
3. Cut a hole in the wall 208 x 152 mm (ensure it is no larger than 214 x 158 mm). Ensure there is a depth from the
surface of the wall of at least 30 mm. If you need to attach the tamper to the wall to meet EN50131, ensure there is
no gap between the rear of the tamper and the wall using suitable packing material.
4. Make a hole in the back or sides of the recessed box and feed the RS485 cable through.
5. Place the recessed box in the hole and tighten the claw fasteners, which rotate 90 behind the plaster board. Continue
tightening until the box is securely held.
6. To meet EN50131, screw the tamper in the recessed box to the wall behind the box.
7. Go to Wiring (page 7) and complete the wiring.
8. Locate the keypad over the recessed box and ensure you can hear the tamper switch click, indicating that it is
closed. Ensure that the keypad sits flat against the recessed box without the need to apply excessive force. If the
keypad won't sit flat against the recessed box or the
switch doesn't click, adjust the tamper screw
(in to allow the keypad to locate and out
to ensure the switch closes).
9. Screw the keypad to the recessed box
using the four screws supplied.
10. Clip the facia in place.
About the System (cont'd)
6