Canon CJ12ex4.3B Operation Manual page 32

1 NOMENCLATURE
1 NOMENCLATURE
4
3
2
1
16
17
Information Display (Digital Drive Unit)
1
DISPLAY
For the operation of the digital drive unit, refer to the "Information Display Manual" on the CD-ROM.
5
6
7
8
9
10
11
12
13
14
15
19
18
2
3
① Iris Gain Adjusting Trimmer
② Instant Auto-Iris Switch
③ Iris Operation Mode Change-over Switch
④ Zoom Rocker Seesaw
⑤ RET Switch (Video Return Switch)
⑥ Memo Switch (Memory Switch)
⑦ AUX Swich
⑧ Flange Back Lock Screw/Flange Back
Adjusting Ring
⑨ Locating Pin
⑩ Macro Button/Macro Ring
⑪ Extender Lever
⑫ Iris Ring
⑬ Zoom Lever/Zoom Ring
⑭ Focus Ring
⑮ Zoom/Focus* Operation Change-over Knob
NOTE) *IASE S and IASE-C S type lenses only.
⑯ Hood Lock Knob
⑰ Zoom/Focus Remote Virtual Connectors
(20-pin)
NOTE) Virtual output port is Connector ★ only.
Use these connectors to connect the control accessory
(equipped with a 20 pin connector) for zooming or focusing.
Connector ★ is also used to connect to the interface of
such as virtual system. It can output each positioning signal
of zoom, focus, and iris.
⑱ VTR Switch
⑲ Max. Zoom Speed Adjusting Volume
① Display Switch
Used to turn the display ON/OFF.
② Display
It turns off if left for 2 minutes without operation.
③ Control key
Used to move the cursor up/down/left/right. Press the
center to confirm.
E2
LENSES