Step 1 Unpacking; Step 2 Inserting Batteries Into The Remote Commander - Sony TA-K800AV Manual

Step 1
Unpacking
Check that you have the following items:
• Remote commander
• Two R6 (size AA) batteries
Step 2
Inserting batteries into the remote commander
Notes
• With normal use, the batteries should last for approximately six months.
• Use two size R6 (AA) batteries.
• If you use the batteries incorrectly, they may leak or explode. See notes
• Do not let direct sunlight or powerful artificial light fall directly on the
4
-EN Getting Started
RMT-K800
1 Turn the commander
over, and remove the
cover.
below for correct usage.
– Insert the batteries with correct polarity as shown above.
– Do not use a new battery together with an old one.
– Do not use different types of batteries together.
– Do not recharge the batteries.
– If you are not going to use the remote commander for an extended period
of time, remove the batteries to avoid possible damage from battery
leakage.
– If battery leakage should occur, wipe off the leakage from the battery
compartment, then insert new batteries.
remote sensor on the front panel of the amplifier. Such light interferes with
the signals from the remote commander, causing the remote commander to
fail to operate correctly.
• AC plug adaptor (attached to the AC plug of
the power cord)
2 Check the polarities and
position two R6 (size
AA) batteries correctly.
TA-K800AV.3-810-853-11 (En, C1, C2)
3 Close the cover.