Appendix A: Safety And Regulatory Notices - Optelec TwinView User Manual

Optelec

Appendix A: Safety and Regulatory Notices

Please read the instructions carefully before setting up your Optelec TwinView. Keep this user
manual for future reference.

Use the TwinView indoors. Do not expose the TwinView to extreme or rapid changes in
temperature or humidity.

Do not place the TwinView near a radiator or heater, or where it may be exposed to direct
sunlight. These conditions may damage the TwinView's electronic components.

Do not place the TwinView on an unstable surface. It may fall, causing serious damage to
the unit, or injury to the user.

The monitor stand contains movable parts. Please be careful when adjusting the stand and
screen position as to prevent fingers or any loose clothing from getting caught in the
operating mechanism. If you have difficulty operating the TwinView safely, please seek
assistance or contact your Optelec distributor.

Contact your Optelec distributor to service this device if necessary. Do not open your
TwinView; this will void the warranty.

Always turn the power off when the TwinView is not in use.

Always unplug the TwinView before cleaning it. Use a soft, damp cloth to clean the exterior
surfaces. Do not use any cleaning agents or any abrasive materials as these will damage
your TwinView.

Only use the power supply or included power connection cable for your TwinView.
Warranty Conditions
Optelec warrants the TwinView, effective from the date of delivery, to be free of any defects in
material and workmanship.
The warranty is not transferable and does not apply to groups, multi-users and agencies. The
TwinView was designed for the individual purchaser to be used at home and work. Optelec
reserves the right to repair or replace any purchased TwinView with a similar or improved product.
In no event shall Optelec or its suppliers be held liable for any indirect or consequential damages.
The original user's remedies are limited to replacement of the TwinView. This warranty is valid only
when serviced in the country of original purchase, and with intact seals. For additional warranty
claims or service during or after warranty period, please contact your Optelec distributor.
Optelec is not responsible for any uses of this device other than those described in this manual.
Compliance
This product complies with the safety and EMC requirements under the following directives:
FCC:
FCC part 15 Class B
Electrical medical equipment requires special precaution with regard to EMC (Electro Magnetic
Compatibility) and must be installed and put into service according to EMC guidelines.
WARNING: The use of accessories and cables other than those specified and sold by the
manufacturer of the TwinView, as replacement parts for components, may result in increased
emissions or decreased functioning of the TwinView.
14
C-Tick
CISPR 22
This device bears the CE, FCC and UL approval mark.
EMC:
EN 50081-1
EN 55022
EN 55024
TwinView
Safety:
UL 60950
English