Changing The Powerbrite Nameplate - Samson PowerBrite Pro7 Owner's Manual

Changing the
PowerBrite Nameplate
After you have received your new Custom Nameplate film, it's a
simple matter to install it. Begin by unplugging your PowerBrite and then
unplug all devices connected to the rear and/or front panel outlets.
Remove the PowerBrite from your rack and use both fingers to press
gently on the two "Push" squares on the slide-out drawer so that it
extends out towards you. With the drawer extended, turn the PowerBrite
upside down. As described on page 10 in this manual, remove the clear
plastic diamond lens at the bottom of the drawer. Then, as shown in the
illustration below, use a Philips-head screwdriver to remove the two
retaining screws holding down the metal nameplate bracket.
Inside the window you will find a slot that holds a four-layer "sandwich"
consisting of a clear cover (#1 in the illustration above, found closest to
the window), logo film (#2), color film (#3), and white diffusor (#4).
Replace the logo film with your new custom Neo-Rack film (the color film
can also optionally be replaced if desired) and then carefully put the
layers back together in the same order, taking care to position the logo
film correctly (it should be upside-down, since the PowerBrite itself is
currently upside-down). Then just slide the "sandwich" back into the slot,
replace the nameplate bracket and clear diamond lens and you're done!
5. Bracket holder
4. White diffusor
3. Color film
SAMSON
2. Logo film
1. Clear cover