Brother HE-800B Service Manual page 30

3. FUNCTION SETTINGS
Item No.
When the
51 : Needle bar moves to the right (+).
: Needle bar moves to the left (-).
When the
52 : Work clamp moves to the front (+).
: Work clamp moves to the back (-).
When the
: Work clamp moves up (+).
53 : Work clamp moves down (-).
At this time, upper thread trimming and lower thread trimming are carried out in conjunction with the
operation of the work clamp.
The buzzer will sound for 0.7 second, and then the sewing machine will start (at the longest for 1 minute).
Immediately after the motor stops, the upper shaft angle (normally around 55) will be displayed.
54
While the motor is stopped, you can press the
and 4000 sti/min).
The buzzer will sound for 0.7 second, then the work clamp will move 15 mm back and forth, and then the
55
cutter will operate.
56 The tension release solenoid will turn on.
The panel indicators will illuminate in order.
57
CAUTION → AUTO → TEST → . . . . → COPY
58 The buzzer will sound.
59 Option output 1 will turn on.
60 Option output 2 will turn on.
61 Option output 3 will turn on.
62 Option output 4 will turn on.
63 Option output 5 will turn on.
64 Option output 6 will turn on.
65 Option output 7 will turn on.
66 Option output 8 will turn on.
67 Option output 9 will turn on.
68 Option output 10 will turn on.
69 Option output 11 will turn on.
70 Option output 12 will turn on.
71 Option output 13 will turn on.
72 Option output 14 will turn on.
73 Option output 15 will turn on.
74 Option output 16 will turn on.
75 Option output 17 will turn on.
76 Option output 18 will turn on.
77 Option output 19 will turn on.
78 Option output 20 will turn on.
21
and keys are pressed, the needle bar will move in units of 1 mm.
and keys are pressed, the work clamp will move in units of 0.1 mm.
and keys are pressed, the work clamp will move in units of 0.12 mm.
Operation
and keys to change the speed (between 1000 sti/min
HE-800B