Chapter 3. Configuration; Configuration Overview - GE PAC8000 series User Manual

Io profinet scanner. programmable control products
Table of Contents

Advertisement

Chapter 3. Configuration

This chapter provides general information for configuring a PAC8000 PNS and its IO modules
in a PROFINET-IO network. For information on configuring the PROFINET IO-Controller and
its network, refer to the IO-Controller manufacturer's documentation.
Note:
This chapter discusses the following topics:

Configuration Overview

3.1
The PAC8000 PNS receives its configuration from a PROFINET IO-Controller, which is
configured by a PROFINET IO configuration tool. The GSDML file provided with the PNS
must be imported into the PROFINET IO configuration tool.
Note:
GFK-2839B
To configure RX3i Controller, refer to the PACSystems RX3i PROFINET Controller
Manual, GFK-2571.
Configuration Overview
o
Basic Configuration Steps
o
Configuration Tool
Adding a PAC8000 PROFINET Scanner to a LAN
o
Configuring PAC8000 PROFINET Scanner Parameters
o
Configuring PAC8000 Module Parameters
Assigning IO-Device Names
Clearing the PROFINET IO-Controller Configuration
Replacing PAC8000 PROFINET Scanner Hardware
For details on using the Proficy Machine Edition PLC Logic Developer programmer to
create and download the configuration for a PAC8000 PNS in an RX3i PROFINET
network, refer to the PACSystems RX3i PROFINET IO-Controller Manual,
GFK-2571.
PAC8000* IO PROFINET Scanner User's Manual–September 2017
Index
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents