Chapter 2. Hardware Installation; Module Installation - GE PAC8000 series User Manual

Chapter 2. Hardware Installation

This chapter describes:
■
■
■
■

Module Installation

2.1
PNS module must be mounted on a horizontal DIN rail. The PNS module fits into a 156mm
deep enclosure.
Rated thermal specifications are based on a minimum clearance of 5.1cm (2 inch) above and
below the module.
In addition to clearances required for cooling, space must be allowed for the following
requirements:
1
2
GFK-2839B
Module Installation
o
Installing the Module on a DIN Rail
o
Removing the Module from the DIN Rail
o
Panel-Mounting
o
Grounding
o
Installing Power Supplies
PNS Powerup and Restart
LED Operation
o
Special LED Blink Patterns
Firmware Updates
o
Installing the USB Port Driver
Allow adequate clearance for communications port cables. For an example, see
below sections.
Allow adequate clearance for power wiring.
PAC8000* IO PROFINET Scanner User's Manual–September 2017
Index
19