Sigmaloop' Detector Family; Interactive' Detector Family - Siemens FDOOT241-9 Technical Manual

4.1.3.3
4.1.3.4
Building Technologies
Fire Safety

'SIGMALOOP' detector family

In SIGMALOOP mode the sensor evaluation takes place in the fire control panel.
The multiple protocol detector is designed such that the parameter set
configuration does not have to be changed.
If the FDOOT241-A4 multiple protocol detector is operated as SDF1200, SDF2200,
or SDF3100 under SIGMALOOP, it can be switched to sensor mode '0' with the
detector exchanger and tester FDUD292.
As it also evaluates the heat sensors, it reacts a maximum of 1.5 times more
sensitively compared to purely optical behavior.
Point detector
SDF1200
SDF2200
SDF3100
SDT2100
Not tested in acc. with EN 54-7
1)
You will find more information in document 007227.
See the chapter 'Applicable documents [➙ 7]'.

'Interactive' detector family

The multiple protocol detector also evaluates its sensor values in interactive mode
according to the S-line parameter sets. The multiple protocol detector is designed
such that the parameter set configuration does not have to be changed.
The selected parameter set can be read out with the detector exchanger and tester
FDUD292 or the intelligent detector tester FDUD293, but it cannot be changed.
Please note that, although they have the same designation, the Sinteso
parameter sets are not identical to the AlgoRex parameter sets. You will find more
information on the Sinteso parameter sets in document 007004.
Undertaking modernization
Step 1: Detector modernization
Parameter set on the control
panel
Standard
P2, P3, P4, P5, P6
Standard, high value
concentration
WM diff, WM high-temp.
4
Selection with FDUD292
Sensor mode '0' option
1)
Sensor mode '0' option
1)
Sensor mode '0' option
1)
-
A6V10323158_d_en_--
2015-04-09
23