Status Word 1; Factory Reset; Transfer Data From Ram To Eeprom - Siemens MICROMASTER 440 Parameter Manual

Issue 01/06
r0968

Status word 1

P-Group: COMM
Displays active status word of inverter (in binary) and can be used to diagnose which commands are active.
Bitfields:
Bit00 Drive ready
Bit01 Drive ready to run
Bit02 Drive running
Bit03 Drive fault active
Bit04 OFF2 active
Bit05 OFF3 active
Bit06 ON inhibit active
Bit07 Drive warning active
Bit08 Deviation setpoint / act. value
Bit09 PZD control
Bit10 Maximum frequency reached
Bit11 Warning: Motor current limit
Bit12 Motor holding brake active
Bit13 Motor overload
Bit14 Motor runs right
Bit15 Inverter overload
P0970

Factory reset

CStat: C
P-Group: PAR_RESET
P0970 = 1 resets all parameters to their default values.
Possible Settings:
0 Disabled
1 Parameter reset
Dependency:
- First set P0010 = 30 (factory settings).
- Stop drive (i.e. disable all pulses) before you can reset parameters to default values.
Note:
The following parameters retain their values after a factory reset:
- P0014 Store mode
- r0039 CO: Energy consumption meter [kWh]
- P0100 Europe / North America
- P0918 CB address
- P2010 USS baud rate
- P2011 USS address
P0971

Transfer data from RAM to EEPROM

CStat: CUT
P-Group: COMM
Transfers values from RAM to EEPROM when set to 1.
Possible Settings:
0 Disabled
1 Start transfer
Note:
All values in RAM are transferred to EEPROM.
Parameter is automatically reset to 0 (default) after successful transfer.
The storage from RAM to EEPROM is accomplished via P0971. The communications are reset, if the
transfer was successful. During the reset process communications will be interrupted. This creates the
following conditions:
- PLC (e.g. SIMATIC S7) enters Stop mode
- Starter automatically recovers communications once they are re-established.
- Drivemonitor is displayed "NC" (not connected) in the status line or "drive busy".
- BOP displays "busy"
After completion of the transfer process, the communication between the inverter and the PC-tools (e.g.
Starter) or BOP is automatically re-established.
MICROMASTER 440 Parameter List
6SE6400-5BB00-0BP0
Datatype: U16 Unit: -
Datatype: U16 Unit: -
Active: first confirm QuickComm.: No
Datatype: U16 Unit: -
Active: first confirm QuickComm.: No
Parameter Description
Min: -
Def: -
Max: -
0 NO 1 YES
0 NO 1 YES
0 NO 1 YES
0 NO 1 YES
0 YES 1 NO
0 YES 1 NO
0 NO 1 YES
0 NO 1 YES
0 YES 1 NO
0 NO 1 YES
0 NO 1 YES
0 YES 1 NO
0 NO 1 YES
0 YES 1 NO
0 NO 1 YES
0 YES 1 NO
Min: 0
Def: 0
Max: 1
Min: 0
Def: 0
Max: 1
Level
3
Level
1
Level
3
109