Special Functions - Siemens SE25M575GB series Repair Instructions

3.5

Special functions

3.5.1 Setting the hardness range
Hold down the S5 button and switch on the appliance. The set value is
indicated on the digital display. The set value increases by one each
time the S5 button is pressed. When the value H:07 is reached, the
display jumps back to H:00. While the hardness range is being set,
the L5 LED flashes. If the appliance is switched off, the value is
saved. (Table below)
°dH °fH °Clarke
0–3 0–6 0–4
4–6 7–11 5–8
7–9 12–16 9–11
10–12 17–21 12–15
13–16 22–29 16–20
17–21 30–37 21–26
22–30 38–54 27–38
31–50 55–89 39–62
Standard setting = H:04
815_58300000003806_ara_en_e.doc – 30.01.12
mmol / l Salt
consumption in
g per rinse cycle
0–0.6 0
0.7–1.1 2
1.2–1.6 4
1.7–2.1 6
2.2–2.9 9
3.0–3.7 14
3.8–5.4 27
5.5–8.9 54
3.5.2 Setting intensive drying
Hold down the S4 button and switch on the appliance. S:00 is indicated
on the digital display. If the S4 button is pressed again, S:01 is displayed
and intensive drying is switched on. When the appliance is switched off,
the value is saved. If intensive drying is activated, the temperature is in-
creased by 3 K in the final rinse to improve the drying result.
3.5.3 De-activating the low rinse-aid indicator
Hold down the S0 button and switch on the appliance. I:01 is indicated
Set value
on the digital display. If the S0 button is pressed again, I:00 is dis-
played and the rinse-aid refill indicator is de-activated.
H 00
H:01
H:02
When the appliance is switched off, the setting is saved. If the low
H:03
rinse aid indicator is de-activated, the temperature is increased by 3 K
in the final rinse to improve the drying result. (see also
H:04
detergent detection)
H:05
H:06
H:07
3.5.4 Programme reset
When the appliance is switched on, press the S4 and S6 buttons for
3 sec. The programme is reset (3x intermittent pumping, then pumping
for approx. 30 sec.).
Then close the detergent dispenser to reset the dispenser.
I:00 = switched off
I:01 = switched on
3 in 1
Seite 7 von 67