Electrolux EXO36HEIWE Installation Manual page 12

Hide thumbs Also See for EXO36HEIWE:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
12 www.electrolux.com
2.9 Wiring connection of indoor
unit
Fig.3
Fig.4
Terminal block of indoor unit
W
CAUTION!
Check the wiring to make sure that
there is no short circuit. Incorrect
wiring can cause malfunction.
Ensure the colour of wires of outdoor
unit and the terminal Nos. are the
same to the indoor's respectively.
When installing the indoor unit to a
Multioutdoor unit the "W" terminal
donot need to be connected.
1.
Open the front panel.
2.
Remove the wiring cover.
3.
Fix the mains cord to the terminal
board (as shown).
4.
Guide the mains cord through the
hole at the back of the indoor unit.
5.
Install the cord anchorage and wiring
cover.
6.
Close the front panel.
Front Panel
1
) L (
2
) N (
S
NOTE:
• The electrical wiring between the indoor
unit and the outdoor unit must be
connected by a qualified electrician.
• Tighten the terminal screws tightly.
Electronic
• After tightening the screws, pull the
box cover
wire slightly to confirm whether it's firm
or not.
• Make sure that the electrical
connections are properly grounded to
prevent electric shock.
2.10 Connective pipe installation
1.
2.
NOTE:
This unit have a both sides drainage
structure, it can be choosen for right,
left or both sides drainage connection. If
choosing both sides drainage connection,
another proper drain hose is needed as
there is only one drain hose offered by
factory. If choosing one side drainage
connection, make sure the drain hole on
the other side is well plugged. For 9k/12k
models, if choosing right side drainage
connection, please choosing right-hand
or right-back piping. The connection of
the drain hose is supposed to be done by
qualified installer in case of water leakage.
Fig.5
Cover for the
right piping
Move and tape the drain hose with piping
in a position as mentioned in Fig.5 above.
For the left-hand and right-hand
piping, remove the pipe cover from
the side panel.
For the right back and left back
piping, install the piping as shown.
Right back piping
Cover for the
left piping

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents