Control Panel Features - Kenmore 796.3142 Series Use & Care Manual

WARNING:
To reduce the risk of fire, electric shock, or injury to persons, read and follow this
entire Use & Care Guide, including the Important Safety Instructions, before operating this washer.
| CONTROL PANEL FEATURES
So_k F_c
_ftener
W_te_ _rgyO
Exp_e_sWash
0
POWER (ON/OFF) BUTTON
Press to turn the washer ON. Press again to turn
the washer OFF. Pressing the POWER button dur-
ing a cycle will cancel that cycle and any load
settings will be lost. The lid wll unlock after a
brief pause.
NOTE: If the washer remains idle for four minutes
after turning the washer ofF, any water left in
the tub will automatically be drained. An alarm
wtl sound one minute prior to draining, and 'dr'
wil appear on the display. You may restart the
washer at this time. However, once the washer
initiates draining, all functions will be suspended
and cycle settings lost, and 'dr_will be displayed
until draining is complete.
O CYCLE SELECTOR BUTTON
Pressthe cycle button to se_edthe desired ctc)e. Once
the desired cycle has been selected, the standard pre-
setswilt appear in the display. These settings can
be adiusted using the cycle setting buttons any time
before starting the cycle.
e
START/PAUSE BUTTON
Press this button to start the selected cycle.
If the washer is running, use this button to pause the
cycle without losing the current settings.
NOTE: if you do not press the START/PAUSE button
within four minutes of selecting a cycle, the washer
automatically turns OFF. If the washer is paused
during a cycle for more than four minutes, the cycle
wil be canceled and any water remaining in the
tub wil be drained. An alarm will sound at three
minutes to warn you that the tub is about to drain.
CYCLE MODIFIER BUTTONS
Use these buttons to adjust the settingsfor the se-
lected cycle. The settings light up above the
buttons to show the current selection.
A
SPECIAL CYCLE AND OPTION BUTTONS
These buttons allow you to
select
special cycles or
options.
TIME AND STATUS DISPLAY
The display shows the cycle status and estimated
time remaining.
NOTE: To protect your clothing, not all settings are available on all cycle selections.
12