Mitsubishi Electric MES3-255C-EN User Manual page 6

 Use the product within the ratings specified in "9. Specifications" of this manual. If it is used outside the ratings, it
may cause not only malfunction or failure but also fire or burnout.
 Settings including an IP address assignment are required to connect the product to the network (Ethernet). Before
use, perform an IP address assignment and other necessary network settings using the supplied configuration
software.(Refer to "IP Setting" of Setting manual)
 The product is configured as follows when shipped from the factory:
IP address = 192.168.10.1, subnet mask = 255.255.255.0, gateway = nothing
When you connect the product directly to a single PC, you do not have to change these settings.
The product has a built-in clock. Before use, set the current date using the supplied configuration software.
Before operating the product, check that active bare wire, etc does not exist around the product.
If any bare wire is found, stop the operation immediately, and take appropriate action such as isolation protection.
6