To Swivel Bath Seat - Safety 1st 44301A User Manual

Setting Up Your Tubside Bath Seat
3. To place the bath seat onto tub, grasp
the Bath Seat and pull the Clamp
Handle underneath the Elbow Cushion
until fully extended.
4. With Clamp Handle fully extended, fit
the Elbow Cushion around the tub
edge. Let the Bath Seat slide down to
the tub floor. Release the Clamp
Handle only when the Bath Seat and
Elbow Cushion are fully resting on the
tub.
CAUTION:
DO NOT use the Bath Seat if:
• the bottom of Red Warning Label
is exposed (Figure 4a).
• the Bath Seat and Elbow Cushion
are not in full contact with the
surfaces of the tub.

To Swivel Bath Seat:

TIP: Choose your desired seat position
before placing your child in the bath
seat.
1. To Swivel Seat: Lift Locking Tab on
back of seat. Rotate seat away from
Elbow Cushion.
NOTE: Seat will only swivel 260
degrees. Do not force seat.
2. To Lock Seat: Push down Locking
Tab on back of seat.
NOTE: Be sure to always lock the seat
before placing a child in the Bath Seat.
3
4
4a
Red
Warning
Label
1
Clamp
Handle
Elbow Cushion
Up to Swivel
Down to Lock
5