Advertisement
S & S Cycle, Inc.
Instruction Sheet #51-1127
14025 County Highway G Box 215
5-08-03
Viola, Wisconsin 54664
Copyright®, 2003
Phone: 608-627-2080 • Fax: 608-627-1488
Technical Service Phone: 608-627-TECH (8324)
by S&S Cycle, Inc.
Technical Service Email: sstech@sscycle.com
Because every industry has a leader
All rights reserved. Printed in the U.S.A.
Website: www.sscycle.com
S&S Twin Cam Style Engine Case Instructions
For all S&S Stock Bore, 4" Bore, and 4
1
/
" Bore Twin Cam style engine cases
8
with Twin Cam style, or Evolution style engine mounting.
All S&S Twin Cam style engine cases are for use in
Type "A" style (non-counterbalanced) applications.
1
Advertisement
Table of Contents
Summary of Contents for S&S Cycle Automobile Parts
- Page 1 S & S Cycle, Inc. Instruction Sheet #51-1127 14025 County Highway G Box 215 5-08-03 Viola, Wisconsin 54664 Copyright®, 2003 Phone: 608-627-2080 • Fax: 608-627-1488 Technical Service Phone: 608-627-TECH (8324) by S&S Cycle, Inc. Technical Service Email: sstech@sscycle.com Because every industry has a leader All rights reserved.
- Page 2 SAFE INSTALLATION AND OPERATION RULES: Before installing any S&S engine part, it is your responsibility to read and follow all instructions. The rules below are for your personal safety, and must be kept in mind at all times. Gasoline is extremely flammable and explosive under certain conditions, and toxic when inhaled.
- Page 3 Instruction Contents: A. Introduction B. Additional Features C. Kit Contents D. Polishing, Painting, Plating, or Powdercoating S&S Crankcases E. Preparation and Installation F. Replacement Parts Please read these instructions thoroughly before starting work. Proceed with the installation only after they are completely understood.
- Page 4 can drastically alter their strength and their critical properties. The degree of change depends upon the temperatures reached and the duration of exposure. When powder coating or otherwise processing alloy parts, S&S exposes them to a maximum temperature of 370°F for no longer than 20 minutes. Under no circumstances should parts be heated past 400°F! E.
- Page 5 If Teflon tape is used, loose tape must not enter crankcase or oil passages. Do not apply tape to first 2-3 threads that screw into hole. If fittings are removed or replaced be sure no tape shreds remain in holes. Tape shred could block oil passages causing restriction of oil flow.
- Page 6 CAUTION - Do not carry the crankcase by the studs. It stresses the crankcase and studs in ways they are not designed to handle. Also, it is easy to drop and damage the case when it is carried by the studs. 8.
- Page 7 Replacement Parts for S&S Twin Cam Style Crankcases 1. Bolt, stator 10-24 x1" SHC - 4 required ..50-0194 (10 Pack) (HD#2720) 2. Seal, sprocket shaft ...31-4035 (HD#12068) 3. Bearing, timken ...31-4013 (HD#9028) 4. Bolt, case 5/16”" -18 x 3-1/2" HHC - 8 required ...50-0147 (5 Pack) 5.
- Page 8 Because every industry has a leader...
Need help?
Do you have a question about the Automobile Parts and is the answer not in the manual?
Questions and answers