If you normally wear glasses or contact lenses, wear them as usual during use (with the exception of reading
glasses). Note that watching with bifocals may be less than optimal.
On one side after another, hold the band release button
down and loosen the headband.
The power indicator on the processor unit is now
lit in green.
Lower the bottom headband strap to the base of your head.
Straighten the front of the unit, so
that it is not tilted downward.
language, and then press the MENU or
Hold the lens span adjusters on both sides and slide
them together until you can see the screen clearly. After
adjustment, press the MENU button or
If you cannot see the screen clearly after lens span
Confirm that all three "" marks and the horizontal line
intersect, and then press the MENU or
All three "" marks and the horizontal
It is acceptable if the "" marks and the horizontal line
intersect in a position other than the center of the screen.
If even one of the "" marks and the horizontal line do
More than one of the "" marks and the
horizontal line do not intersect.
After reading the information, press the MENU or
Wearing the unit will prevent you from seeing outside the display. Before you put it on, take a moment to review steps 2 – 4
(Wear, Set up, and Enjoy), so that you know the sequence of operations.
Top headband strap
Bottom headband strap
Headband, release button
Pull out the headband.
Turn the system on (
Bring the headband strap down around
the back of your head.
Straighten the unit
on your head.
Follow the instructions displayed on the
screen for operations.
Select a display language (first time
button to select a
Adjust the lens span.
adjustment, start over from "2 Wear. "
Check display alignment.
not intersect, stop using the system. For details, see the
"Reference Guide. "
Follow the instructions displayed.
Control playback from compatible playback sources.
Controlling Playback from the Unit
Hold the button down
to jump to the previous
Hold the button down to
enter standby mode.
For details on configuring menu settings and attaching accessories, see the
"Reference Guide. "
Tighten the headband gently.
Gently tighten the headband, evenly on both sides. If the top
or bottom headband strap is too loose, adjust the length.
Adjust the position on your head.
Carefully adjust the unit left and right (and up and down, as
needed) to find the best position for viewing the center of
Tighten the headband securely.
Support the unit with both the forehead supporter and
the bottom headband strap. Do not support the unit
with the bridge of your nose.
Fasten it to keep it level on your head.
If the unit tips forward, lower the bottom headband strap to
balance the unit on your head.
Adjust the headphones.
Move the headphones forward, back, up, or down to position
them over your ears.
To remove the head mounted unit
Hold the band release buttons on both sides and pull the unit
forward as you lift it off.
Hold the button down to jump
to the next chapter.
The system cannot be used for advanced
playback equipment control, such as menu
Control using these buttons is only possible
when the "Control for HDMI" in "General Setup"
is set to "On" (default setting).
Some playback equipment cannot be
controlled using the head mounted unit