Honeywell Thor CV41 User Manual page 61

6. For Association, choose WPA or WPA2.
7. For 8021x, choose None.
8. For Pre-Shared Key, enter the pre-shared key or passphrase.
9. Save your settings.
Configure 802.1x Security With Wireless Security
Use the following procedure to configure 802.1x-WEP security with Wireless security.
Honeywell recommends that you use WPA2-802.1x instead of 802.1x-WEP if possible.
1. Make sure the communications and radio parameters on your computer are config-
2. Make sure Wireless is selected as your security choice.
3. Start Intermec Settings.
4. Choose Communications > 802.11 Radio > Wireless Security.
5. Select the profile you want to configure.
6. For Association, choose Open.
7. For Encryption, choose WEP.
8. For 8021x, choose TTLS, PEAP, or TLS.
9. If you chose TTLS or PEAP:
10. If you choose TLS:
11. Save your settings.
Configure LEAP Security With Wireless Security
After you configure the communications and radio parameters on your computer and
select Wireless as your security choice, you can configure LEAP.
1. Start Intermec Settings.
2. Choose Communications > 802.11 Radio > Wireless.
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Guide
The pre-shared key must be a value of 32 hex pairs preceded by 0x for a total of 66
characters. The value must match the key value on the access point. The passphrase
must be from 8 to 63 characters. After you enter a passphrase, the computer
internally converts it to a pre-shared key. This value must match the passphrase on
the authenticator.
ured.
a. Enter a User Name.
b. For Prompt for Credentials, choose Enter credentials now.
c. Enter a User Password.
i. For Validate Server Certificate, choose Yes.
a. Load a user and root certificate on your computer. For help, see
Certificate.
b. For Validate Server Certificate, choose Yes.
c. Enter a User Name and Subject Name.
Load a
53