Select Microsoft Security As Your Security Choice - Honeywell Thor CV41 User Manual

•

Select Microsoft Security as Your Security Choice

Microsoft Security is enabled by default. If it is not, you need to select it as your security
choice to use it. After you select Microsoft security as your security choice, you will be
prompted to save your settings and reset the computer for your changes to take effect.
With Microsoft as your security choice, you can configure:
•
•
•
Select Microsoft Security
Use the following procedure to select Microsoft security.
1. Start Intermec Settings. For help, see
2. Choose Communications > 802.11 Radio > Security Choice.
3. From the Security Choice list, select Microsoft Security. An alert box appears
4. Tap Yes. The computer resets and starts with Microsoft Security as the Security
Configure WPA or WPA2 Enterprise (802.1x) Security With Microsoft Security
Use these procedures to set WPA-802.1x security on your computer with Microsoft
security.
1. Make sure the communications and radio parameters on your computer are config-
2. Tap Start > Network Connections. The Network Connections screen appears.
3. Tap and hold onto the Wireless Network Connection icon until the pop-up screen
4. Tap the Wireless Networks tab.
5. Make sure your wireless network you are configuring is selected and tap the
6. For Network Authentication, choose WPA or WPA2 and select TKIP or AES. The
7. Tap the Authentication tab and choose, choose either PEAP or Smart Card or other
48
If you are using the computer in a static environment that requires a high level of
security, you should use Wireless security, which offers CCX v4.0 compliance,
support for LEAP and TTLS, and configuration for up to four profiles.
To use Wireless security, you need to select Wireless security as your security choice
and select profile. For help, see the next section,
WPA or WPA2
802.1x
Static WEP
telling you that you must save your settings and reboot the computer for the new
security choice to take effect.
Choice.
ured.
appears and select Properties.
Properties button.
Encryption type automatically defaults to AES.
certificate.
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Guide
Select a Wireless Security
Start Intermec Settings.
Profile.