Eletech Hold-n-Tell DP-400 User Manual

Trouble Shooting

1. The power light is on but there is no sound.
a. Make sure the output level is turned up.
b. Turn on the internal speaker by pressing down the Speaker Button on
case top. If the audio can be heard from the internal speaker, then the
audio patch cord is probably loose.
c. If the audio cannot be heard from the internal speaker, then the flash
card may have been installed improperly. To fix this problem, turn the
power off and re-install the flash card.
2. It's playing the wrong track.
Hold-n-Tell
TM
Press the Change Button momentarily to advance to the next track. Re-
peat this process until the desired track is reached.
3. The sound quality is poor.
DP-400 MP3 On-Hold System
The output level is properly too high - turn it down with the VOL Dial.
User's Manual

Three Year Limited Warranty

Eletech Electronics, Inc. warranty obligations are limited to the terms set
Revision 1.1
forth below:
(c) 2004, 2005 Eletech Enterprise Co. Ltd.
Eletech Electronics, Inc. ("we" or "us") warrants this PRODUCT against
All rights reserved
defects in materials and workmanship to the original purchaser, under
normal use and conditions, for a period of THREE (3) YEARS from the
* Hold-n-Tell is a trademark of Eletech Enterprise Co. Ltd.
date of original purchase.
If you discover a defect, we will at our option, either repair the PRODUCT
with new or refurbished replacement parts, or replace the PRODUCT if
we are unable to restore it to good working order after a reasonable
number of attempts at no charge, subject to verification of the defect or
malfunction and proof of the date of purchase.
This limited warranty does not apply to damage caused by (1) a direct
lightning strike, (2) misuse, neglect, casualty, or improper installation,
(3) repairs done or attempted by someone not authorized by us, (4)
improper use, maintenance or modification of this PRODUCT, or (5) any
other cause outside of our control. This Limited Warranty does not apply
to anyone other than the original purchaser of the PRODUCT.