Installing / Mounting - Siemens SINAMICS G120P Hardware Installation Manual

Installing / mounting

WARNING
To ensure the safe operation of the equipment, it must be installed and commissioned by
qualified personnel in full compliance with the warnings laid down in this manual.
Take particular note of the general and regional installation and safety regulations
regarding work on dangerous voltage installation (e.g. EN 61800-5-1) as well as the
relevant regulations regarding the correct use of tools and personal protective equipment
(PPE).
General rules for protecting Power Modules against environmental effects
To ensure that the Power Module is installed in the correct environmental conditions, please
ensure that you adhere to the following guidelines:
• Power Modules FSA ... FSF are designed for degree of protection IP55. There is limited
protection against the ingress of dust (no damaging deposits) and against splashing
water from all directions (slight ingress of water is permissible).
• Although the Power Module is protected against the ingress of water, this protection is
dependent however on all the seals being correctly installed (e.g. seals when mounting
an operator panel).
• Direct solar radiation is not permissible
• Keep the Power Modules free of dust and dirt.
• Keep the Power Modules away from solvents and chemicals.
• The temperature of the Power Module must lie within the
operating temperature range.
• Ensure that the correct level of ventilation and air flow is
provided.
• Ensure that all Power Modules are grounded according to the
guidelines provided in this document.
PM230 Power Module IP55
Hardware Installation Manual, 11/2014, A5E35319202B AA
3
19