Reversing The Door Position: Qhe03Ggm - Haier QHE02GGM User Manual

INSTALLATION INSTRUCTIONS

REVERSING THE DOOR POSITION: QHE03GGM

WARNING
Follow all steps when reversing the door
swing. Failure to follow these instructions, leaving off parts,
or overtightening screws, can lead to the door falling off and
result in injury and property damage.
• Ensure the appliance is unplugged and empty.
• Adjust the two leveling legs to their highest position.
• We recommend you have someone assist you.
TOOLS REQUIRED
• 10 mm socket screw driver
• Phillips style screw driver
PARTS INCLUDED
1. Upper Hinge Bracket
2. Leveling Legs
3. Machine Screw
4. Bottom Hinge Bracket
5. Door Stopper
NOTE: To take the door off, it is necessary to tilt the
appliance backward. You should rest the appliance on
something solid, e.g. a chair, just below the top panel.
DO NOT lay the appliance completely flat as this may damage
the coolant system.
1. Unscrew the top hinge cover screw and remove cover.
Unscrew the upper hinge bracket screws and remove
hinge. Take off the left side screw covers. Pull the appliance
door upward to remove.
2. Remove left leveling leg and door stopper by unscrewing
the mounting screws.
49-60800-2
3. Install the leveling leg, door stopper, and bottom hinge
bracket on the opposite bottom side. Tighten the screws
on the door stopper and bottom hinge bracket.
4. Slide the door onto the bottom hinge pin. Replace the
upper hinge bracket on the opposite side and check to
make sure the door/hinge is moving smoothly. Tighten the
screws of the upper hinge bracket. Replace the hinge cover
and right side screw covers. Tighten the hinge cover screw.
5. Check that the door is aligned, horizontally and vertically,
and that the seals are closed on all sides before finally
tightening the upper hinge screws and hinge cover screw.
Readjust the leveling legs.
9