Figure 4: PMPN4380_ Charging Procedure
1. Place the Multi-Unit Charger (MUC) on a flat surface.
2. Firmly insert the power supply into the charger DC Inlet Socket at
the back of the charger.
3. Plug the power supply power cord into a matching power outlet.
4. Upon successful power-up, each pocket LED shows Green for one
second and IMPRES 2 CHARGER is displayed. If the LEDs do not
flash and no message is displayed, check power cord connections.
5. Insert the radio with battery or stand-alone battery into an available
pocket.
6. When the radio or stand-alone battery is properly seated in the
pocket:
• Charging status of a radio is indicated by the LED Status
Indicator and/or display of the radio.
• Charging status of a stand-alone battery is indicated by the LED
Status Indicator of the associated pocket on the MUC.
• The Display of the MUC shows the charging status of Pocket 1
only.
7. The radio or stand-alone battery is ready for use when the LED is
Steady Green.
8. Only turn on the radio while in iTM Communication mode.
Otherwise, turn off the radio.
16