Installation; General - Hatco HWBRN-FUL Installation And Operating Manual

SPECIFICATIONS
Dimensions — HWB-11QT Models
Models:
HWB-11QT HWBRN-11QT
HWB-11QTD HWBRN-11QTD
HWBH-11QT HWBHRN-11QT
HWBH-11QTD HWBHRN-11QTD
Diameter
(A)
12-5/16"
(313 mm)

INSTALLATION

General

Built-In Heated Well units are shipped from the factory with
most components assembled and ready for use. Use the
following procedures to install the unit.
WARNING
ELECTRIC SHOCK HAzARD:
• Unit must be installed by a qualified electrician.
Installation must conform to all local electrical codes.
Installation by unqualified personnel will void unit
warranty and may lead to electric shock or burn, as well
as damage to unit and/or its surroundings.
• Unit is not weatherproof. Locate the unit indoors where
the ambient air temperature is a minimum of 70°F
(21°C).
FIRE HAzARD:
• Install unit with a minimum of 3-1/2" (89 mm) from
bottom of unit to all combustible surfaces to prevent
combustion.
• Unit must be installed using ribbon putty gasket
between unit and installation surface per installation
instructions (refer to INSTALLATION section of this
manual).
Locate the unit at the proper counter height in an area that
is convenient for use. The location should be strong
enough to support the weight of the unit and contents.
NOTICE
Units are voltage-specific. Refer to specification label for
electrical requirements before beginning installation.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to the unit.
HWBRT-11QT
HWBRT-11QTD
HWBHRT-11QT
HWBHRT-11QTD
Height
(B)
8-3/4"
(222 mm)
CAUTION
B
Figure 17. Dimensions — HWB-11QT models
Remote mounted control panels must have a minimum 6"
(152 mm) clearance from unit (not to exceed 72" [1829
mm]). Mounting control panel closer may cause heat
damage to electrical system in control panel.
Damage to any countertop material caused by heat
generated from Hatco equipment is not covered under the
Hatco warranty. Contact the manufacturer of the
countertop material for application information.
NOTE: All Built-In Heated Wells require the control box be
remote mounted in the vertical position.
1. Remove the unit from the box.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImPORTaNT OWNER INFORmaTION section for
details.
2. Remove tape and protective packaging from all surfaces
of unit.
NOTE: A qualified electrician is recommended for connecting
the Built-In Heated Well units to a power source. A
qualified plumber is recommended for connecting
drain.
3. Install the unit in the desired location. Use the appropriate
procedure in this section for combustible or non-
combustible countertops.
IMPORTANT NOTE:
For bottom mount units, see "Installing a Bottom mount Unit"
in this section before performing any countertop cutouts.
4. Install the remote mounted control box (refer to the
procedure in this section).
12
A
NOTICE
Form No. HWBm-0511