Table of Contents
Advertisement
Quick Links
High End Residential
In-Ground Basketball System
Owners Manual
Customer Service Center
• N53 W24700 South Corporate Circle • Sussex, WI 53089 • U.S.A.
Write Model Number
WARNING!
From Box Here:
READ AND UNDERSTAND
OPERATOR'S MANUAL
BEFORE USING THIS UNIT.
FAILURE TO FOLLOW
OPERATING INSTRUCTIONS
COULD RESULT IN INJURY
OR DAMAGE TO PROPERTY.
Toll-Free Customer Service Number for U.S: 1-800-334-9111
Hydra-Rib Internet Address: http://www.hydra-rib.com
Spalding Internet Address: http://www.spalding.com
1
10/05
ID# M8672412
Advertisement
Table of Contents
Related Manuals for HYDRA-RIB M8672412
Summary of Contents for HYDRA-RIB M8672412
-
Page 1: Owners Manual
READ AND UNDERSTAND OPERATOR'S MANUAL BEFORE USING THIS UNIT. FAILURE TO FOLLOW OPERATING INSTRUCTIONS COULD RESULT IN INJURY OR DAMAGE TO PROPERTY. Toll-Free Customer Service Number for U.S: 1-800-334-9111 Hydra-Rib Internet Address: http://www.hydra-rib.com Spalding Internet Address: http://www.spalding.com 10/05 ID# M8672412... -
Page 2: Safety Instructions
• 3 People • Carpenter’s Level • 15’ Tape Measure • Shovel & Post Hole Digger • Wood Board (scrap) ID# M8672412 10/05 • (2) Stepladders 8 ft. (2.4 m) • (1) Utility Knife • Safety Goggles • Phillips-Head Screwdriver •... -
Page 3: Parts List
Bolt, Hex, 1/2-13 x 2.5, Black Zinc 204921 Washer, Barrel 204922 Pin, Hitch 204923 Pin, Cotter, #8 204670A Bushing, Plastic 204670B Bushing, Plastic 204670C Bushing, Plastic * You May Have Extra Parts With This Model. PARTS LIST ID# 516000 06/05 10/05 ID# M8672412... - Page 4 Item #5 (4) Item #22 (9)* Item #25 (12) Item #26 (1) HARDWARE IDENTIFIER (OTHER - NOT ACTUAL SIZE) Item #37 (1) Item #35 (1) Item #38 (14) Item #39 (4) Item #40 (8) Item #36 (1) ID# M8672412 10/05...
- Page 5 Make sure J-bolts (19) are in the illustrated position. Nuts on the top of plate are used for leveling the pole after system is fully assembled. 24" (61 cm) GROUND SURFACE 48" (121.9 cm) 2.75” (7 cm) 24" (61 cm) 48" (121.9 cm) PLAYING SURFACE 10/05 ID# M8672412...
-
Page 6: Side View
(2) must be parallel with playing surface. IMPORTANT!: TO NEXT STEP. CONCRETE MUST CURE. ALLOW ADDITIONAL TIME FOR COLD, WET OR HUMID WEATHER. ID# M8672412 10/05 PLAYING SURFACE WAIT A MINIMUM OF 72 HOURS BEFORE GOING ON DRAINAGE HILL 1"... - Page 7 Insert bushings (38, 39, and 40) into areas shown. IMPORTANT! Bushing types are identified with a letter. 10/05 ID# M8672412...
- Page 8 REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Insert bolt (28) through holes in plate and pole and secure with nut (22). ID# M8672412 10/05 PLAYING SURFACE PLAYING SURFACE SCRAP WOOD (NOT INCLUDED)
-
Page 9: Completed Assembly
3-3/4” from the end of the rod (14) as shown (Figure A). WARNING! THREE PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Completed Assembly FIGURE 10/05 ID# M8672412... - Page 10 While still in forward position, attach both upper and lower yokes (17 & 18) to pole as shown. WARNING! THREE PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. ID# M8672412 10/05...
- Page 11 Attach elevator adjustment (12) to lower yoke (18). WARNING! THREE PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. 10/05 ID# M8672412...
- Page 12 Attach elevator adjustment (12) to pole bracket. WARNING! THREE PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. ID# M8672412 10/05...
- Page 13 (18), FIG. C, and secure with hardware as shown in FIG. D. WARNING! THREE PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. FIG. C FIG. D 10/05 ID# M8672412...
- Page 14 Remove rim cover (16), attach rim assembly (3) to backboard (10) and reattach rim cover (16). ** For rim assembly see instructions included with rim. FIGURE Rim Assembly ID# M8672412 10/05 Refer To Instructions Included With Rim Hardware For Rim Assembly.
- Page 15 7 8 9 10 IMPORTANT! NOTE ORIENTATION OF HEIGHT INDICATORS: 10’ MARK SHOULD FACE AWAY FROM BACKBOARD. 7 8 9 10 7 8 9 10 7 8 9 10 10/05 7 8 9 10 7 8 9 10 ID# M8672412...
- Page 16 RAISE THE SYSTEM UPRIGHT. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. ID# M8672412 10/05 Upright pole (1) by tightening nut (26). Using 15/16” wrench, turn nut (26) clockwise to begin standing pole upright. Continue to turn nut (26) until pole has come to rest against washers (24) and pole is vertical.
- Page 17 WARNING! ONLY AFTER THE ANCHOR PLATE HAS BEEN FULLY TIGHTENED: Remove cotter pin (37) and pin (36) to remove threaded assembly rod (14) from anchor plate (2). 10/05 ID# M8672412...
- Page 18 WARNING & HEIGHT ADJUSTMENT LABELS BEFORE USING THIS UNIT. FAILURE TO FOLLOW OPERATING INSTRUCTIONS COULD RESULT IN INJURY OR DAMAGE TO PROPERTY. ID# M8672412 10/05 NOTE: If adjustment is necessary, adjust system by rotating the nuts (25) between anchor plate (2) and pole flange.
-
Page 19: What Is Not Covered By This Warranty
RIms are not warranted for any defects other than workmanship. Torn back plates, damaged springs, bent rings, damaged eye bolts, and torn or distorted rim supports result from hanging on the rim and are not warranted. ® ® ® system 10/05 ID# M8672412...
Need help?
Do you have a question about the M8672412 and is the answer not in the manual?
Questions and answers