Mattel DLV45 Instructions

0890 2,4 GHz
Mattel Europa B.V. (located at Gondel 1, 1186MJ Amstelveen, The Netherlands) hereby declares that this toy is in compliance with the essential requirements and other relevant provisions of
Directive 1999/5/EC. A copy of the Declaration of Conformity may be obtained from Mattel Europa B.V. at the above address.
Includes one 3.7V Rechargeable LiPo Battery Pack for Hover board.
Requires 3 AAA alkaline batteries (not included) for the Controller.
Dispose of batteries safely. Call or go to website for replacement propeller installation instructions.
Safety Information and Notes
CAUTION: To prevent entanglement, keep hair away from propellers.
CAUTION: Do not attempt to grab the rotating propeller.
CAUTION: If propeller(s) are damaged, do not fly Hover Board. Flying with damaged propellers may lead to injury.
IMPORTANT: Please read all instructions before operating your Hover Board.
Only use the product under the supervision of an adult. Take care to ensure during use that there is a sufficiently large space between people, animals and objects.
Do not put objects into the propeller.
This product is not recommended for use on loose dirt or wet surfaces. Do not immerse in water.
IMPORTANT: DO NOT touch Hover Board with metallic objects. The product might short circuit causing damage.
Stay at least 3 to 6 feet away from the Hover Board. That goes for anyone watching as well.
Always keep an eye on the Hover Board. If it looks like it's going to crash into you, your friends or anything else, release the throttle joystick and step out of the way.
Never disassemble or attempt to modify the product.
LiPo Battery Information
DO NOT RECHARGE THE HOVER BOARD IF IT FEELS HOT. ALLOW IT TO COOL BEFORE RECHARGING.
DO NOT ATTEMPT TO USE OR CHARGE THE HOVER BOARD IF IT SHOWS SIGNS OF LEAKAGE OR CORROSION.
DO NOT DISASSEMBLE THE HOVER BOARD PERMANENTLY INSTALLED LIPO (LITHIUM POLYMER) BATTERY. THE LIPO BATTERY IS A SEALED LIPO BATTERY.
IF THE HOVER BOARD AND/OR CONTROLLER ARE WET, THOROUGHLY DRY BEFORE USING OR CHARGING.
REGULARLY EXAMINE ALL CONNECTORS. IN THE EVENT OF DAMAGE, DO NOT USE.
REPLACE BATTERIES IN CONTROLLER IF HOVER BOARD CANNOT PERFORM PROPERLY AFTER THE HOVER BOARD FULLY CHARGED.
When exposed to an electrostatic source or the Hover Board malfunctions, turn the power OFF and ON again. This should reset your Hover Board and let it resume normal operation.
To avoid accidental operation, always turn switches OFF and remove all batteries for storage.
ADULT NOTE: To remove LiPo battery for disposal: turn off unit, cut out battery from the foam casing, use scissors to cut wire, wrap wire end with tape to isolate it, repeat with remaining wires.
Dispose of LiPo battery in accordance with your local laws.
Contents: Please remove everything from the package and compare to the contents shown here. If any items are missing, please contact your local Mattel office. Keep these instructions for future
reference as they contain important information.
INSTRUCTIONS INSTRUCTIONS
INDOOR USE ONLY.
© 2016 Mattel. All Rights Reserved.
8+ 8+
DLV45
Adult assembly required to
attach replacement propellers.
DLV45-0970-G1
1100979139-DOM