Bosch B426 Installation And Operation Manual page 11

Conettix Ethernet Communication Module
Notice!
Remove all power (AC and Battery) before making any connections. Failure to do so may
result in personal injury and/or equipment damage.
Notice!
Use either the terminal strip wiring or interconnect cable to wire to the control panel. Do not
use both. When connecting multiple modules, you can combine terminal strip and
interconnect wiring connectors in series.
Run the wiring connections from the module to the data bus terminals on the compatible
control panel. Connect the Ethernet cable to the Ethernet port on the module.
Figure 4.2: Using terminal strip or interconnect cable wiring (GV4 control panel shown)
Callout ᅳ Description
1 ᅳ SDI2 control panel. For SDI control panels, wire R, Y, G, B to the SDI bus.
2 ᅳ Module
3 ᅳ To Ethernet network
4 ᅳ Terminal strip wiring
5 ᅳ Interconnect cable (P/N: F01U079745) (included)
Figure 4.3: Wiring to an option bus terminal strip
Callout ᅳ Description
1 ᅳ Compatible control panel (FPD-7024 control panel shown)
2 ᅳ Module
Bosch Security Systems, Inc. Installation and Operation Guide
Installation | en 11
2016.08 | 08 | F.01U.266.226