Related Manuals for Force RC HAMMERJAW
Summary of Contents for Force RC HAMMERJAW
- Page 1 ™ HAMMERJAW 1/10 4WD ELECTRIC ROCK BOUNCER FCES03000 INSTRUCTION MANUAL MANUEL D’UTILISATION...
-
Page 2: Table Of Contents
Parts Diagram (Front and Rear Ends) ........28 When You Are Finished ............8 Parts Diagram (Drivetrain) ............. 29 Motor Care ................8 Parts Diagram (Body and rollcage) ........29 Maintenance ................9 Parts Diagram (Interior)............30 2-in-1 Electronic Speed Control (ESC)/Receiver ......9 ™ HAMMERJAW... -
Page 3: Water Resistant Vehicle With Water-Resistant Electronics
WATER-RESISTANT VEHICLE WITH WATER-RESISTANT ELECTRONICS • Driving in wet conditions can reduce the life of the motor. The Your new Force RC Hammerjaw™ Rock Bouncer has a special additional resistance of operating in water causes excess water-resistant coating on the electronics to ensure reliable strain. -
Page 4: Box Contents
BOX CONTENTS 1. Force RC Hammerjaw ™ (FCES03000) ® 2. Force RC Pistol Grip Transmitter (FCES 13008) ® 3. 200mA Battery Charger (DYNC1031) 4. Dynamite ® Speedpack ® SPEEDPACK 2000mAh 7.2V Ni-MH battery (DYNB0020) 5. AA batteries (4) SPECIFICATIONS Frequency 2.4GHz... -
Page 5: Installing Transmitter Batteries
3 Connect battery to ESC. If desired, you can put foam blocks (ECX1053) in front of the battery so the weight of the battery increases rear traction or in back of the battery to increase steering response and crawling capabilities. ™ HAMMERJAW... -
Page 6: Transmitter Controls
Power ON or OFF the transmitter at the steering wheel turned left or right Steering Wheel Controls RIGHT and LEFT steering Throttle Trigger Controls power to the motor for forward or reverse Forward Stop Reverse ™ HAMMERJAW... -
Page 7: Getting Started
IMPORTANT: Seat the motor brushes by driving smoothly on a fl at surface during use of the fi rst battery charge. Properly seating the motor brushes will increase the life and performance of the motor. INSTALLING THE VEHICLE BODY ™ HAMMERJAW... -
Page 8: Operation
• Over-temperature protection is installed on the ESC to • Prolong motor life by preventing overheating conditions. prevent circuit damage, but cannot protect the motor from Undue motor wear results from frequent turns, stops and driving against heavy resistance. ™ HAMMERJAW... -
Page 9: Maintenance
Connect to battery LIPO 5V DC NIMH Steering Servo Included Part # Replacement Part # Description DYN1171 DYN1171 Motor DYNB0020 DYNB0020 7.2V Battery SPMS605 SPMS605 Steering Servo FCES13002 FCES13002 Receiver/ Electronic Speed Control (ESC) DYNC1031 DYNC0500 Battery Charger ™ HAMMERJAW... -
Page 10: Component Specifi Cations
• When properly filled, the piston should rebound about 3/8 in (9.5mm) after being pushed in fully. • Re-install the shock on the vehicle. Item # Part # Description FCES233005 Shock absorber set, Hammerjaw FCES233006 Shock spring set, Hammerjaw FCES234007 Linkage Ball Cup and Shock Plastics Set, Hammerjaw ™ HAMMERJAW... -
Page 11: Troubleshooting Guide
• Do a check of the wires and connection between operation between battery and receiver battery and receiver. Repair or replace wires and/or connectors Receiver loses its • Transmitter accidentally put in bind mode, • Bind transmitter to receiver bind ending bind to receiver ™ HAMMERJAW... -
Page 12: Limited Warranty
Horizon directly. This will enable Horizon Product for a period of 60 days from notifi cation, after which to better answer your questions and service you in the event that you it will be discarded. 10/15 ™ HAMMERJAW... -
Page 13: Contact Information
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. ™ HAMMERJAW... -
Page 14: Replacement Parts
Ball Stud Set, Hammerjaw Piton à rotule, Hammerjaw FCESS231009 Chassis Brace and Battery Tray Set, Hammerjaw Support du châssis et support de batterie, Hammerjaw FCESS231011 Front/rear Upper and Lower Link Mounts, Hammerjaw Supports de liaison supérieur et inférieur avant / arrière,... -
Page 15: Recommended Tools
RECOMMENDED TOOLS / OUTILS RECOMMANDÉS 2 mm 1.5 mm PARTS DIAGRAM (CENTER CHASSIS) VUE ÉCLATÉE DES PIÈCES (CHÂSSIS CENTRAL) ™ HAMMERJAW... -
Page 16: Parts Diagram (Front And Rear Ends)
PARTS DIAGRAM (FRONT AND REAR ENDS) VUE ÉCLATÉE DES PIÈCES (EXTRÉMITÉS AVANT ET ARRIÈRE) REAR END EXTRÉMITÉ ARRIÈRE FRONT END EXTRÉMITÉ AVANT Wheel/Tire assembly Ensemble roue/pneu ™ HAMMERJAW... -
Page 17: Parts Diagram (Drivetrain)
PARTS DIAGRAM (DRIVETRAIN) VUE ÉCLATÉE DES PIÈCES (GROUPE MOTOPROPULSEUR) PARTS DIAGRAM (BODY AND ROLL CAGE) VUE ÉCLATÉE DES PIÈCES (CORPS ET CAGE DE ROULEAU) 2, 3 ™ HAMMERJAW... - Page 18 PARTS DIAGRAM (INTERIOR SET) VUE ÉCLATÉE DES PIÈCES (ENSEMBLE INTÉRIEUR) ™ HAMMERJAW...
- Page 19 © 2018 Horizon Hobby, LLC. Force RC, the Force RC logo, Hammerjaw, Dynamite, Speedpack and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other trademarks, service...
Need help?
Do you have a question about the HAMMERJAW and is the answer not in the manual?
Questions and answers