Download Print this page

Honda RIDGELINE 2019 Owner's Manual: Honda Sensing- If Equipped; Cruise Control- If Equipped; Adaptive Cruise Control (acc)- If Equipped; Lane Keeping Assist System

Hide thumbs


Honda Sensing
is a driver support system
which employs the use of two distinctly
different kinds of sensors, a radar sensor
located in the front grille and a front sensor
camera mounted to the interior side of the
windshield, behind the rear view mirror.
These are the components of Honda
Adaptive Cruise Control (ACC)
: Helps
maintain a constant vehicle speed and a
set following interval behind a vehicle
detected ahead of yours, without you
having to keep your foot on the brake or the
Road Departure Mitigation (RDM) System
Alerts and helps to assist you when the
system detects a possibility of your vehicle
unintentionally crossing over detected lane markings and/or leaving the
roadway altogether.
Lane Keeping Assist System (LKAS)
vehicle in the middle of a detected lane and provides tactile and visual alerts if
the vehicle is detected drifting out of its lane.
Collision Mitigation Braking System
a possibility of your vehicle colliding with a vehicle or a pedestrian detected in
front of yours. The CMBS
is designed to alert you when a potential collision is
determined, as well as to reduce your vehicle speed to help minimize collision
severity when a collision is deemed unavoidable.
Cruise Control
Maintain a constant vehicle speed without having to keep your foot on the
accelerator pedal. Use cruise control on freeways or open roads where you
can travel at a constant speed with little acceleration or deceleration.
Cruise control is not available when Snow, Mud
Intelligent Traction Management (see Intelligent Traction Management System.
108 |
The camera is located
behind the rearview
Radar Sensor
The radar sensor is
inside the front grille.
: Provides steering input to help keep the
: Can assist you when there is
or Sand
is selected for
*1 - If equipped
Activating and Setting the Vehicle Speed
1. Press the CRUISE button. The
CRUISE MAIN indicator appears.
2. Accelerate to the desired speed
(above 25 mph/ 40 km/h). Take your
foot off the pedal and press the
-/SET button to set the speed. The
Adjusting the Vehicle Speed
Press the RES/+ button to increase speed or the -/SET button to decrease
Each time you press the button, the
vehicle speed is increased or
decreased by about 1 mph (1.6 km/h). If
you keep the button pressed, the
vehicle speed increases or decreases
until you release it.
| 109


Comments to this Manuals

Symbols: 0
Latest comments: