Download Print this page

Motorola SDC1000 Operating Manual page 11

Single door access controller
Hide thumbs

Advertisement

SDC1000
¨ ë Now, the Main Unit is entered to normal operation mode with default setting.
10-3. Registration of PIN ONLY MODE
¨ ç Turn switch on DC12V Power Supply.
All 3 LEDs will be flashing with starting sound.
¨ è Press 0 3
ENT
¨ é Enter a 8 digits PIN number +
digits PIN number +
Master PIN number to finish setup.
8digits PIN
ENT
Master PIN
¨ ê First 8 digits PIN number is registered as Master PIN and 4~6 digits PIN followed
to Master PIN are registered as User Access PIN numbers then type Master PIN
again to finish setup.
(Please write and remember Master PIN number for further setting changes.)
¨ ë Now, the Main Unit is entered to normal operation mode with default setting.
10-4. Default Setting Values
After the Initial Setup, the Main Unit stores its default setting values as follows and run
normal operation mode. If you want to change the setting values, add or delete USER
Access Cards(or PIN) then please refer to "Setting Changes" in section 8.
¨ ç When User Access Card(or PIN) is granted
- Door RELAY activates for 3sec.
- Green LED lights on for 3sec.
¨ è When User Access Card(or PIN) is denied
- Alarm RELAY activates for 2sec.
- Red LED lights on for 2sec.
from the keypad.(PIN ONLY MODE )
ENT
to register User Access PIN numbers then type 8 digits
ENT
4~6digits PIN
User Access PIN
SINGLE DOOR ACCESS CONTROLLER
to register Master PIN number then type 4~6
...
8digits Master PIN
ENT
...
Master PIN(Finish setup)
- 11 -
MOTOROLA
ENT

Advertisement

loading

  Related Manuals for Motorola SDC1000