Please read carefully before use 1- DESCRIPTION OF YOUR APPLIANCE 1- Cap (EP4630) 2- Depilator head 3- Massaging beads 4- Tweezers 5- Release button for remo- vable head 6- 2-speed and stop switch 7- Adaptor 8- Cleaning brush 9- Exfoliator head (EP4630) 10- 2 exfoliating bands 11- Sensitive Area accessory (EP4630)
2 - SAFETY Voltage : Ensure that this voltage corresponds to that of your mains supply. Incorrect connection may cause irreparable damage which is not covered by the guarantee. This appliance is intended for personal domestic use only. It must only be used with the enclosed adaptor EM2A2. Never use if the appliance (depilator or adaptor) is damaged or in the event of any damage caused by dropping the appliance (invisible damage may be dangerous).
4. CONNECTION 5. STOPPING THE APPLIANCE 6. PEELING Peeling will enable you to: - Limits growth of subcutaneous hair if practised regularly. We strongly recommend that you use the Exfoliator Head 2 days before using your epilator to avoid irritating your skin. •...
Page 6
• After peeling, we advise you to wipe over the area with a moist flannel to remove any dead skin. Dry the skin tho- roughly afterwards. • Method : - Press the release button to remove the epilator head. - Clip the Exfoliator Head to the epilator. - Set the switch to “1”...
Page 7
7. LEG HAIR REMOVAL For optimum epilation, we recommend that you tilt the epilator slightly towards your skin in the direction of epi- lation, as shown in the diagram. - Move the switch to the on position “2 “ . 8.
For the bikini line: Important: Make sure the skin is stretched properly. Remove the Sensitive Area accessory and unplug your epilator after each use. 9. CLEANING THE APPLIANCE • Cleaning the epilator head: 1. Unplug the epilator. 2. Press the release button on the head and remove the epilator head. 3.
Page 9
• Cleaning the Exfoliator Head. We recommend that you change the exfoliating band after three sessions of exfoliation or when it is worn out. Do not clean the band under running water. - Do not apply alcohol to the body of the appliance to avoid its colours changing.