Rover 45048, 45148 Owner's Manual
  1. Manuals
  2. Brands
  3. Rover Manuals
  4. Lawn Mower
  5. 45048, 45148
  6. Owner's manual

Rover 45048, 45148 Owner's Manual

Reel mower
Hide thumbs
Table of Contents

Advertisement

Quick Links

Owners Manual
MODEL 45
TM
REEL MOWER
MODELS 45048 & 45148
TM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 45048, 45148 and is the answer not in the manual?

Questions and answers

Related Manuals for Rover 45048, 45148

Summary of Contents for Rover 45048, 45148

  • Page 1 Owners Manual MODEL 45 REEL MOWER MODELS 45048 & 45148...

  • Page 2: Table Of Contents

    Rover Mowers Limited Thank you for buying a Rover Mower. This manual covers the operation and maintenance of the Rover Model 45 understand this owners manual, and the accompanying engine manufacturers manual. If any point is unclear, contact Rover Mowers Limited or any authorised Rover Mower service dealer.

  • Page 3: Safety Instructions

    6. Check all nuts, bolts and screws often, always be sure the mower is in safe operating condition. Use only genuine Rover replacement parts. 7. Refuel out doors only. Do not smoke while fuelling engine. Add fuel before starting the engine.

  • Page 4: Assembly

    Rover Mowers Limited 1.1 UNPACKING 1. Lift the top off the carton base and place to one side. 2. Pivot the upper handlebars into the upright position, and secure with the clamp screw and nut. Do not damage the clutch and throttle cables.

  • Page 5: Controls

    Rover Mowers Limited 2. CONTROLS 2.1 Throttle control Located on the right hand arm of the handle bars. Marked for slow and fast positions. Figure 2. Figure 2. Throttle control. 2.2 Drive clutch lever. Located on the left hand arm of the handle bars bars.

  • Page 6: Starting

    Rover Mowers Limited 3.1 STARTING Disengage the ‘Cutter drive lever’. Figure 4 Move the ‘Choke control lever’ located on the engine to the choke position. Move the throttle control lever to the fast position. Figure 2. Grasp the engine starter cord and pull rapidly to start the engine.

  • Page 7: Adjusting

    If, after adjusting the cutter setting, a satisfactory cut cannot be achieved, the blades may require sharpening or replacement. Return the mower to an authorised Rover Mower service dealer for blade sharpening and setting. Model 45 Figure 7. Cutter adjustment.

  • Page 8: Clutch

    Rover Mowers Limited 4.4 CUTTING HEIGHT The cutting height is adjusted with the front roller adjustment knob (A) Figure 9. To raise the cutting height, turn the knob clock- wise. To lower the cutting height, turn the knob anti-clockwise. CAUTION When setting LOW cut, ensure that the front roller contacts the ground and not the bottom blade.

  • Page 9: Maintenance

    Rover Mowers Limited 5.1 LUBRICATION To gain the optimum performance from your mower, the following areas need to be oiled every five hours of operation. The same grade oil as used in the engine is suitable. CAUTION Bearings are sealed for life and do not require lubrication. 1. Clutch Thrust Pad (1) - looking through the left hand oil port hole in the clutch cover apply three drops of oil in the thrust pad oil hole.

  • Page 10: Trouble Shooting

    TROUBLE SHOOTING Rover Mowers Limited Model 45...
  • Page 11 Rover Mowers Limited Model 45 NOTES...

  • Page 12: Warranty Conditions

    Product Model no: ... Product Serial no: ... Date of purchase: ... Rover Mowers Limited reserves the right to make changes of and add improvements upon its product at any time without notice or obligation. The company also reserves the right to discontinue manufacture of any product at its discretion at any time.

This manual is also suitable for:

45

Table of Contents

Save PDF