Dräger Infinity M300 series Supplemental Manual page 30

Infinity M300+
Pacer detection
Amplitude
Width (dp)
ST segment analysis
Leads analyzed
Isoelectric point
ST measurement point
ST complex
Update interval
ST measurement and alarm
limit ranges
ST measurement resolution
ST measurement accuracy
Pulse oximetry (optional)
Parameter display
Measurement method
Measurement and display
range
Calibration range
Display update period
Maximum hold from previous
update
30
Infinity M300+ specifications
Leads I and (II or lll)
±2 to ±700 mV
0.1 to 2.0 ms
3-wire lead set: I, II, or III
5-wire lead set: I, II, III, aVL, aVR, aVF, V
6-wire lead set: I, II, III, aVL, aVR, aVF, V, V+
6-wire lead set with Infinity TruST: I, II, III, aVL, aVR, aVF, dV1,
V2, dV3, dV4, V5, dV6
Default: –28 ms (before J-point)
Default: +80 ms (after J-point)
Length: 900 ms (250 samples)
Frequency response: 0.05 to 40 Hz
15 s
–15.0 to +15.0 mm, –1.5 to +1.5 mV
0.1 mm (0.01 mV)
± 0.5mm (0.05 mV) or 15 % RTI (with respect to input) whichever
is greater for all leads, excluding STVM and STCVM
Pulse oximetry oxygen saturation percentage (SpO2), pulse rate
Absorption-spectrophotometry
SpO2: 1 to 100 %
Pulse rate: 30 to 250 bpm
70 to 100 %
2 seconds nominal
30 seconds (in the event of artifact or other error)
Supplement – Infinity M300 and M300+ Series – VG2.4