Rotel RX-975 Owner's Manual

Rotel RX-975 Owner's Manual

Am/fm stereo receiver
Hide thumbs Also See for RX-975:

Advertisement

Owner's Manual
RX-975
AM/FM Stereo Receiver

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RX-975 and is the answer not in the manual?

Questions and answers

Summary of Contents for Rotel RX-975

  • Page 1 Owner’s Manual RX-975 AM/FM Stereo Receiver...
  • Page 2 • Reorient or relocate the receiving antenna. • Increase the separation between the unit and the televi- sion tuner. • Connect the unit to an AC power outlet on a different elec- trical circuit. • Consult your authorized Rotel retailer for assistance.
  • Page 3 English Figure 1: Controls and Connections...
  • Page 4 RX-975 AM/FM Stereo Receiver Figure 2: RR-949 Remote Control Figure 3: Antenna Connections...
  • Page 5: Input Connections

    English Figure 4: Input Connections...
  • Page 6 RX-975 AM/FM Stereo Receiver Figure 5: Output Connections...
  • Page 7: Table Of Contents

    Contents Figure 1: Controls and Connections Figure 2: RR-949 Remote Control Figure 3: Antenna Connections Figure 4: Input Connections Figure 5: Output Connections About Rotel ... 8 Getting Started ... 8 Unpacking Placement Main Operating Controls ... 8 Power Switch...
  • Page 8: Main Operating Controls

    Remove the unit carefully from its packing. Look for the handheld remote control and other accessories. Save the packing and box as it will protect the RX-975 if you move or need to return it for maintenance. Placement Place the RX-975 on a solid, dry, level sur- face away from direct sunlight, excessive heat, high humidity, or strong vibrations.
  • Page 9: Input Source Buttons

    This will preserve memory func- tions. : The STANDBY switch also controls NOTE the rear panel AC outlets. When the RX-975 is in STANDBY mode, the AC outlet is also off. When the RX-975 is fully functional, the AC outlet is live.
  • Page 10: Band Button

    FM signal is received. NUMERIC Buttons: Station Presets The RX-975 can store up to 30 station pre- sets for recall at any time using the NUMERIC buttons. To memorize a station: 1. Tune to the desired station, AM or FM.
  • Page 11: Power Button

    Front Panel Controls section of this manual if you need additional information. AUDIO Button To operate the RX-975 with the remote, make sure that the AUDIO mode is active by press- ing the AUD button on the remote before you start.
  • Page 12: Video 2 – 5 Inputs

    INPUTS on the audio tape deck. Connect a second tape deck to the TAPE 2 connections – the outputs of the tape deck to the IN jacks on the RX-975 and the OUT jacks on the RX-975 to the inputs on the tape deck.
  • Page 13: Preamp Inputs/Outputs

    RX-975 and the negative speaker terminal to the correspond- ing black connector on the RX-975. Route the wires from the RX-975 to the speak- ers. Give yourself enough slack so you can move the components to allow access to the speaker connectors.
  • Page 14: Remote External Sensor

    Two AC outlets let you plug a power cord from a source component or other accessory into the back of the RX-975 so that it will be turned on and off automatically. The outlet is powered whenever the RX-975 is fully active and off when it is in STANDBY mode.
  • Page 15: Specifications

    All specifications are accurate at the time of printing. Rotel reserves the right to make improvements without notice. Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan. Audio Continuous Amplifier Power: Total Harmonic Distortion:...
  • Page 16 The Rotel Co. Ltd. 10-10 Shinsen-Cho Shibuya-Ku Tokyo 150-0045 Japan Phone: +81 3-5458-5325 Fax: +81 3-5458-5310 Rotel of America 54 Concord Street North Reading, MA 01864-2699 Phone: +1 978-664-3820 Fax: +1 978-664-4109 Rotel Europe Meadow Road Worthing, West Sussex BN11 2RX...

Table of Contents