Download  Print this page

Advertisement

Re-install the toner cartridge. If re-installing the toner cartridge fails to clear the error message, the toner
cartridge may be faulty. Contact the store where you purchased the toner cartridge or consult the Canon
Customer Help Center.
Procedure for Replacing the Toner Cartridge(P. 244)
Check the authentication settings.
The authentication method set on the machine does not match the authentication method set on the
RADIUS server.
Check that the same authentication method is set on this machine and the RADIUS server, and set the
correct authentication method.
Configuring IEEE 802.1X Authentication Settings(P. 170)
Cooling down... Wait a moment, then try again.
The temperature of the fixing assembly is high.
Wait for a while until the fixing assembly cools down. After the temperature of the fixing assembly falls, try
the operation again.
Cooling down... Wait a moment.
The temperature of the fixing assembly is high.
Wait for a while until the fixing assembly cools down. After the temperature of the fixing assembly falls,
the message will disappear.
Could not connect. (for Access Point Mode connection)
Connection in Access Point Mode failed due to an error.
Wait a few moments and try again. If you still cannot connect, turn OFF the machine, and then turn it back
on again.
Connecting Directly (Access Point Mode)(P. 126)
Could not connect. (for Easy Connection via PC connection)
An error has occurred while starting Easy Connection via PC (cableless setup mode).
Press the Back key to return to the previous screen, and then try <Easy Connection via PC> again.
If the same message still appears after retrying <Easy Connection via PC>, turn OFF the machine, and then
turn it back on again.
Troubleshooting
287

Advertisement

Table of Contents

   Also See for Canon imageClass LBP162dw

   Related Manuals for Canon imageClass LBP162dw

Comments to this Manuals

Symbols: 0
Latest comments: