Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 87

Patient monitor..
Hide thumbs

Advertisement

Measurement Settings
Factory Defaults
Item Name
MAC
No Al. til Breath
AutoStandbyAfter
1/3
Setup Agent
1.Setting only available when using a G1 (M1013A).
2.Setting only available when using an AGM (M1026A/B).
3.Setting only available when using a G5 (M1019A).
General Gas Analyzer Configuration Implications
Agent This setting is available when using the M1013A IntelliVue G1 only. It lets you select the agent
that will be analyzed by the M1013A.
Setup Agent This operation is available when using the M1013A IntelliVue G1 and the M1019A
IntelliVue G5 only. To configure the individual settings for each anesthetic gas for the IntelliVue G1 and
G5, select Setup Agent, and then in the Setup Agent menu, select the agent and adjust the settings as
needed.
No Al. til Breath If set to set On, the monitor suppresses alarms from the Gas Analyzer until it
detects that a patient has been connected to the gas analyzer (when breathing is detected).
AutoStandbyAfter This setting defines the time after which the gas analyzer automatically goes into
Standby when no breath is detected. During Standby, the gas analyzer's gas sample intake pump and other
internal components are automatically switched off to increase the lifetime of the device. The message GM
(or AGM) STANDBY is shown on the monitor.
O
Settings
2
Measurement Settings: Main Setup -> GM (or AGM) -> O
Factory Defaults
Item Name
inO
High
2
inO
Low
2
inO
Alarms
2
O
2
Scale
Unit
Color
Oper.
MX800,
Mode
MP5 - MP90 (H30)
C M Profile Adult
x
x not a setting, see "Configuring MAC (Minimum Alveolar Concentration)" on page 93
x
On
x
120
x
not a setting, see "General Gas Analyzer Configuration Implications" on page 87
Oper.
MX800,
Mode
MP5 - MP90 (H30)
C M Profile Adult
x
x 100%
x
x 18%
x
x On
x
x et + in
x
x 100
x
%
x
Green
4 Configuration Settings Appendix
Profile Pedi
Profile Pedi
Profile Neo
2
Profile Neo
87

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: