Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 73

Patient monitor..
Hide thumbs

Advertisement

Measurement Settings
2.Setting available for M3014A only.
CO
Configuration Implications
2
The On/Off state of the CO
CO
2
switched On when a CO
This setting lets you switch the inspired minimum CO
imCO
2
imCO
value is the smallest CO
2
unphysiological CO
The imCO
2
N2O Corr. This settings lets you correct the CO
the ventilation gas mixture, you must turn this on. If this setting is not available in the Setup CO
menu, the CO
or it is setup with Gas Corr. (see below).
Gas Corr. This settings allows correction of CO
Helium or N
setting is not available in the Setup CO
Extension Module does not require N
Corr. (see above).
Agent Corr. This setting lets you correct the CO
agents: Halothane, Enflurane. Isoflurane, Sevoflurane, Desflurane. Corrections can be applied between
0.0% and 20.0%. If any of the specified anesthetic agents is present in the ventilation gas mixture, you
must select the appropriate concentration.
Oxygen Corr. This settings lets you correct the CO
mixture. If this setting is not available in the Setup CO
Measurement Extension Module does not require O
Max Hold If Max Hold is configured to
CO
value measured within the previous 10 or 20 seconds. If set to Off the etCO
2
breath-to-breath value.
HumidtyCorr This setting determines the method used to correct the influence of water vapor in the
patient's breath on the CO
Standard Temperature Pressure Dry (STPD). Setting HumidtyCorr to BTPS takes the partial pressure
contributed by the water vapor into consideration and therefore results in lower CO
compared to STPD. For an exact definition and the formula used, see the section on "Measurement
Specifications" in the "Installation and Specifications" chapter of the monitor's Instructions for Use.
Configuring awRR from CO
Measurement Settings: Main Setup -> Measurements -> awRR
AwRR can be derived from the CO
of the CO
measurement extension modules (Microstream, Sidestream, or Mainstream), or by the
2
integrated CO
derived from an anesthetic gas analyzer.
measurement cannot be preconfigured. CO
2
transducer is connected to the monitor.
2
concentration measured during inspiration. This helps you to detect
2
concentrations in the inspired gas.
2
High limit defines the alarm limit for the imCO
measurement in your Measurement Extension Module does not require N
2
O is present in the ventilation gas mixture, you must make the appropriate selection. If this
2
2
reading. The options are Body Temperature Pressure Saturated (BTPS) or
2
(Airway Respiration Rate)
2
measured by an anesthetic gas analyzer (AGM, G1, or G5), or by any
2
measurement in the MP5. The settings listed in this section do not apply for the awRR
2
2
reading for proportions of N
2
reading for proportions of Helium or N
2
menu, the CO
measurement in your Measurement
2
2
O or Helium correction, or the N
reading for proportions of the following anesthetic
2
reading for proportions of O
2
menu, the CO
2
correction.
2
or
10 sec
20 sec
4 Configuration Settings Appendix
is automatically
2
(imCO
) numeric On or Off. The
2
numeric.
2
O. If N
2
O correction is setup with N2O
2
in the gas
2
measurement in your
2
, the etCO
numeric shows the highest
2
numeric shows
2
readings when
2
O is present in
2
2
O correction
2
O. If
2
73

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: