Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 67

Patient monitor..
Hide thumbs

Advertisement

Measurement Settings
Factory Defaults
Item Name
CCO Low Limit
Alarms
CCI settings
CCI High Limit
CCI Low Limit
Alarms
CCO Configuration Implications
Alarms From To set CCO alarms to be triggered by the indexed CCO value, set Alarms From to
CCI.
The CCO From setting defines the arterial pressure source for CCO. The following pressure labels can
be used as pressure source for the CCO: ABP, Ao, ART, UAP (plus FAP and BAP if Full is selected as
the Label Set, see see "Global Settings" on page 168).
PPV From CCO This setting lets you switch the PPV calculated from the CCO measurement On or
Off. Pulse Pressure Variation can be calculated in two different ways on this monitor - in conjunction
with the continuous cardiac output measurement, or directly from the invasive pressure measurement.
Note that this setting does not apply to the PPV calculated from the pressure measurement.
CCO The On/Off state of the CCO measurement cannot be preconfigured. CCO is automatically
switched On when an appropriate C.O. transducer is connected to the monitor.
Configuring SVR
MX800
Measurement Settings: Main Setup -> Measurements -> SVR
MP20-90
SVR is a derived measurement.
only
Factory Defaults
Item Name
Label
Arterial Source
Set CVP
SVR
Measurement
Color
Oper.
MX800,
Mode
MP20 - MP90
C M Profile Adult Profile
Pedi
x
x 4.0 l/min
2.6 l/min
x
x On
2
x
x 4.3 l/min/m
3.7 l/min/m
2
x
x 2.0 l/min/m
2.6 l/min/m
x
x On
(Systemic Vascular Resistance)
Oper.
MX800,
Mode
MP20 - MP90
C M Profile Adult
x
x SVR
x
x ABPm
x
x 0 mmHg
x
x Off
x
Enabled
x
green
4 Configuration Settings Appendix
X2
Profile
Profile
Profile
Neo
Adult
Pedi
0.3 l/min
2
2
5.2 l/min/m
2
2
1.2 l/min/m
Profile Pedi
Profile
Profile
Neo
Outdoor
4.0 l/min
4.3 l/min/m
2.0 l/min/m
Profile Neo
67
2
2

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: