Download  Print this page

Philips IntelliVue MX800 IntelliVue MP2 Configuration Manual Page 63

Patient monitor..
Hide thumbs

Advertisement

Measurement Settings
a red alarm is signalled when the limit is violated. Be sure to set the clamps beyond the configured pressure
limits.
Configuring Pulse from Invasive Pressure
Not
Measurement Settings:
Main Setup -> Measurements -> <Press Label> -> Pulse (<Press Label>)
MP5T
MP5SC
Factory Defaults
Item Name
High Limit
Low Limit
Pulse Alarms
AlarmSrc (ECG)
Pulse (<Press Label>)
System Pulse
QRS Volume
Δ ExtrTachy
Tachy Clamp
Δ ExtrBrady
Brady Clamp
Alarms Off
AlarmSource Sel.
PulseAlarms Tele
Pulse from Invasive Pressure Configuration Implications
Pulse (<Press Label>) This setting lets you switch the Pulse from the related Invasive Pressure
label On or Off. If you switch Off a Pulse that is currently selected as the source for the System Pulse (see
"Configuring the System Pulse" on page 41), the monitor will use the next available Pulse from the list of
possible pulse sources as system pulse.
Configuring CPP
Measurement Settings: Main Setup -> Measurements -> CPP
CPP is a derived measurement. The measurement unit used for the CPP calculation depends on the unit
setting for arterial source and ICP.
Oper.
MX800,
Mode
MP2 - MP90
X2
C M Profile Adult
x
x not applicable, see "Configuring ECG/Pulse Alarms" on page 38.
x
x
x
x
x
x
x
x On
x
x not applicable, see "Configuring the System Pulse" on page 41.
x
x not applicable, see "Configuring User Interface Settings" on page 126.
x
not applicable, see "Configuring ECG/Pulse Alarms" on page 38.
x
x
x
x
x
x
(Cerebral Perfusion Pressure)
4 Configuration Settings Appendix
Profile Pedi
Profile Neo
63

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: